How do you turn off ABS light?
Locate the DIC control panel on the dashboard in front of the driver’s seat under the speedometer. Keep pushing and releasing the “Set” button on the DIC control panel until “ABS” is shown. Hold the “Set” button for about 5 seconds to reset the light and turn it off.
What causes the ABS warning light to come on?
The two reasons for an ABS light to come on are to test the function of the bulb or to warn the driver that some type of fault has occurred in the anti-lock brake system. Some of the common reasons for an ABS light to come on include: Standard bulb check. Low fluid.
How does bad wheel bearing affect ABS?
Unless the bearing was so bad that the wheel had visible movement in it it will not affect the ABS, noisy bearings do not affect the ABS. If you bearing was so bad it was affecting the alignment a quick check by grasping the wheel and giving it a shake would detect this.
What does the ABS warning light mean?
A problem in the ABS or traction control system is usually indicated by a warning light. When the ABS warning light is on, it means that the ABS has been shut down because of a mechanical or electrical failure.
How do you reset ABS control module?
Plug the computerized scan tool into it and power on the scan tool. Navigate to the “ABS” menu on the computerized scan tool by pushing the down arrow button. Select “Clear all codes.” Power off the computerized scan tool and disconnect it from the DLC connector. Turn on the vehicle and verify that the ABS module is no longer lit.
How do you test ABS speed sensor?
To properly test the ABS sensor you would need an oscilloscope to display the wave form. You can use a voltmeter to check for a voltage pulse when the wheel is turned. This test is not very acurate. If you received a fault for a front wheel speed sensor you can switch them from side to side. Be careful as ABS module failure is more likely.
Where is the ABS brake sensor?
A wheel speed sensor, also called an “ABS sensor,” is part of the Anti-lock Brake System (ABS). It is located on the tires (near the brake rotors for the front tires and in the rear end housing for the rear tires).