How do you reset the timing belt light on a Toyota Land Cruiser 79?
the reset procedure of the timing belt light is all done by pressing the trip meter button and holding it in whilst the ignition is turned to on then select from the trip button then continue pressing until you come to 15 on trip metre, turn off and then restart. The light should then go off.
How do you reset the timing belt light on a 2006 Toyota Land Cruiser?
b) While pressing the trip switch, turn the ignition switch ON and hold it for 5 seconds. c) Release the trip switch, then press the switch again within 5 seconds. d) The digital display should change to T-belt mode.
How do you reset the timing belt light on a 2003 Toyota Land Cruiser?
What does T belt light mean?
It’s just a reminder that it’s time for a new belt.
How to reset timing belt on Toyota Landcruiser?
This is tutorial on how to reset timing belt on Toyota Dyna / Toyota Landcruiser (Same procedure for both). 1. T-BELT MODE DISPLAY b) While pressing the trip switch, turn the ignition switch ON and hold it for 5 seconds. c) Release the trip switch, then press the switch again within 5 seconds. d) The digital display should change to T-belt mode.
How to reset the timing belt warning indicator?
Timing Belt Warning Indicator Reset Procedure. For LandCruiser UZJ100, HZJ105 and HDJ100. a) With ignition turned ON, using the trip switch (select/reset button) change the display to ODO, and turn the ignition OFF. b) While pressing the trip switch, turn the ignition switch ON and hold it for 5 seconds.
How to turn off the T Belt Light on a Toyota Land Cruiser J200?
To turning off the T-belt Light on 2008, 2009, 2010, 2011, 2013, 2014, 2015 Toyota Landcruiser J200, conform to the following instructions: Turn the ignition switch to the “On” position, but do not start the engine. If your car has START push-button, press the “Start” without touching the brake pedal. Press the odometer button until you see “ODO”.
How does the reset button work on a Land Cruiser?
The worm drive passes over a small black box that has electrical connections to the reset button. So, the black box must have a cog attached to the worm drive (can’t see it) and the box counts six increments of the 10,000 mile digit and then triggers the light. The reset button tells it to stop counting and start again.