How do you reset passkey on Saturn Ion?
Resetting the PASSKEY can be necessary at times if the programming in the module becomes corrupted or if a new key and key cylinder are installed. To reset the system, get in the car and shut the door. Turn the key on to the “Run” position without cranking the engine. Leave the key there for exactly 10 minutes.
How does the security system work on a Saturn Ion?
The Ion uses two systems that provide different functions, but for the same purpose: to prevent theft. The Ion uses a passive alarm system that arm when you exit the vehicle and lock the doors with the keyless remote. If at any time the doors are opened without the use of the remote or the keys the alarm will sound.
Why is my Saturn Ion not turning off?
The problem with the Saturn ION’s not turning off, I.E. ignition will not turn to the off position is with the lock cylinder. Specifically the retaining clip that holds the tumblers and springs in place. I just replaced a lock cylinder on my girlfriends car because the only way she could stop the engine was to stall out her manual transmission.
How do you turn off the engine on a Saturn Ion?
Turn the key to the off position without removing it and back to “Run” for 10 more minutes. Turn the key off again and back to “Run” for 10 minutes a third. Turn the key off and then attempt to start the engine.
The Ion uses a passive alarm system that arm when you exit the vehicle and lock the doors with the keyless remote. If at any time the doors are opened without the use of the remote or the keys the alarm will sound. This is to prevent the theft of contents within the car.
What should the circuit resistance be on a Saturn Ion?
There’s an open in the circuit resistance is above 200 ohms and a loose terminal or a faulty module if below 200 ohms. Measure the resistance between the crankshaft position sensor’s terminals A and B. (Disengage the DIS module’s five-pin connector first). The resistance should be 700 to 900 ohms.
Can you change the ignition key on a Saturn?
Plenty of owners have made modifications to their ignitions and the result can be some unexpected non-factory solutions to issues of Saturn car key replacement. But if there is nothing custom about your Saturn’s locks/security don’t worry about that either.
Can a Saturn dealer cut a replacement key?
A: Yes. Saturn dealers, like other car brand dealer, use a code to cut a replacement key. These types of codes are available only for limited years, usually about 10 years or so. Therefore, if your Saturn model is older than ten years ago, you may have a problem of getting a replacement key from the dealer.
Do you need a new ignition key for a Saturn Aura?
Furthermore, remember to ask if the key needs to be programmed or coded, some models do – e.g., a replacement key for 2008 Saturn Aura will need to be programmed, whereas a 1996 Saturn SC won’t. If you think you need a new ignition switch/ lock cylinder, first make sure you don’t simply need a new key.
Resetting the PASSKEY can be necessary at times if the programming in the module becomes corrupted or if a new key and key cylinder are installed. To reset the system, get in the car and shut the door. Turn the key on to the “Run” position without cranking the engine. Leave the key there for exactly 10 minutes.
The Ion uses a passive alarm system that arm when you exit the vehicle and lock the doors with the keyless remote. If at any time the doors are opened without the use of the remote or the keys the alarm will sound. This is to prevent the theft of contents within the car.
Turn the key to the off position without removing it and back to “Run” for 10 more minutes. Turn the key off again and back to “Run” for 10 minutes a third. Turn the key off and then attempt to start the engine.
How can I Reset my Volkswagen security system?
Volkswagen Security System Reset. To deactivate the anti-theft system use the unlock button on the remote key. Unlock the driver’s door using the key and then switch the ignition switch to the on position. If that doesn’t work exit the vehicle and roll up all windows, then use the key to lock the driver’s door.
How to solve the anti theft system car wont start?
Reset the car’s computer. It is another way to solve the problem of anti theft system car wont start. Disconnect the positive terminal of the battery for a minute or two. Reconnect it and make sure that both the anode and cathode terminals are tightly attached.
How to reset a security system on a Saturn Ion?
To reset the system, get in the car and shut the door. Turn the key on to the “Run” position without cranking the engine. Leave the key there for exactly 10 minutes. Turn the key to the off position without removing it and back to “Run” for 10 more minutes.
Is there an anti theft system on a Saturn Ion?
But most of today’s vehicles come equipped with an anti-theft system that is integrated into the vehicle’s computers. The 2007 Saturn Ion is one of them. The Ion uses two systems that provide different functions, but for the same purpose: to prevent theft.
How does the PASSKey System on a Saturn Ion work?
The PASSKEY system uses an exciter coil located inside the key lock tumbler that detects the correct key being inserted and turned to start the car. When the correct key is turned in the cylinder it sends a signal to the computer which will then allow the fuel injectors to function.
Where can I get a new Saturn key?
An automotive locksmith for Saturn keys replacement can do that on-site. Alternatively, you can contact the dealer, but the car will have to be towed there. Fob car key – Fob remote “push to start” car key: Usually looks like some sort of remote.
What happens if you change the ignition key on a Saturn?
A previous ignition change may result in different keys for the ignition and doors. Most Saturn models today are equipped with chips or transponders, so make sure you mention the exact year, make and model and ask the locksmith if they have the necessary tools in their truck to code the key.
A previous ignition change may result in different keys for the ignition and doors. Most Saturn models today are equipped with chips or transponders, so make sure you mention the exact year, make and model and ask the locksmith if they have the necessary tools in their truck to code the key.
An automotive locksmith for Saturn keys replacement can do that on-site. Alternatively, you can contact the dealer, but the car will have to be towed there. Fob car key – Fob remote “push to start” car key: Usually looks like some sort of remote.
Why does my car not start when I reset the passkey?
If the wrong key is used or if the system is tampered with, the car will not start. Resetting the PASSKEY can be necessary at times if the programming in the module becomes corrupted or if a new key and key cylinder are installed. To reset the system, get in the car and shut the door.
Why is the ignition key stuck in my Saturn Ion?
New BTSI solenoid fixed my 2007 Saturn Ion when the key would not rotate out of the ignition lock cylinder after car was placed in Park. Thanks for the tip. I figured it had something to do with the car not registering that it was in park, because sometimes, I was able to get the key out by shifting the gears in and out of park several times.
What to do when your car key is stuck?
When I go to shut off the ign. sw. after driving the ign. key won’t shut all the way off and you can not remove the key. The key operates just fine. I can start the car, turn the engine off but the key won’t turn all the way off to release the key.
Why does my ignition key keep getting stuck?
ALSO (another “tip” from the Service Manager), “HAVE A MINIMUM NUMBER OF KEYS ON YOUR KEY RING”… because the weight of the keyring will SLOWLY deteriorate Your Ignition Switch!! RESPECTFULLY, “JO JO” I had the same problems and apparently it is a part called the BTSI switch or module. I just got it out of the dealership today and it works fine.