How do you replace a lower control arm on a Honda?
Remove the 17mm bolt and 14mm bolt holding the suspension fork and remove it from the vehicle. There’s no spring pressure once both wheels are jacked up and in the air. Put a huge breaker bar and break the 17mm rear bushing bolt free.
How do you remove an upper control arm?
Position a floor jack under the lower ball joint or control arm to relieve downward pressure on the suspension components. This will enable you to remove the upper control arm without pressure bearing down on the arm. You might need to remove any small wiring or brake flex hose clips to free up the arm for removal.
Where does the lower control arm connect to?
Thus the lower control arm connects to the subframe at the front and back, to the suspension fork, stabilizer linkage and to the steering knuckle via the lower ball joint. First break the front 19mm bolt free with a breaker bar. Note all the cracks on the bushings, due for replacement.
How to replace the upper control arm and ball joint?
Place the large C-clamp from the kit over the cylinders. Use the ½-inch drive air gun and socket to push the ball joint out. Reverse the process to install the ball joint. Install the upper control arm in reverse order of removal.
How to replace Honda Accord lower control arm?
Step 1: Control Arm Overview. The Accord uses double wishbone front suspension. Step 2: Front Bushing Bolt. Step 3: Stabilizer Linkage. Step 4: Suspension Fork. Step 5: Rear Bushing Bolt. Step 6: Lower Ball Joint. Step 7: Old Control Arm.
Where is the lower control arm located on a car?
A lower control arm must be disconnected from the lower ball joint (attached to the steering knuckle) and from the vehicle frame or body. An upper control arm is disconnected from the strut tower on the body and from the top of the steering knuckle.
Is it possible to replace a control arm?
Replacement of a control arm is generally an intermediate DIY repair. On some vehicles, the control arms come with the bushings already installed. On other vehicles, the bushings need to be pressed into their housings on the control arm before installation into the vehicle. In this case, the repair will be more difficult.
How is the control arm attached to the steering wheel?
The control arm is connected on one end to the steering knuckle (to which the wheel is attached by way of the hub and bearing assembly) by a ball and socket called a ball joint. It is attached at the other end to the vehicle frame or body.