How do you remove a Jack digital antenna?
The familiar “Batwing” crank handle is removed using an Allen wrench. Once removed 3 pieces will fall into your hand. Using a #2 Phillips, the detent plate is removed from the ceiling.
How does a Jack antenna work in a RV?
An Allen screw holds it in place. When the handle comes off, the spring and the detent ring come with it. Next the base of the detent plate becomes visible. 4 screws secure the plate into the ceiling. Once removed all that remains is the shaft that turns the batwing.
What makes a Jack digital HDTV antenna rust?
At the top of the batwing, a piece of coax rolls out of the legs and connects into the head amp of the antenna. Pulling the rubber boot back displayed a white powdery coated F connector which is nothing more than corrosion. Toward the 6 o’clock position of the connector, the corrosion was so bad that the nut itself appeared to be rusted through.
How long is the coax for a Jack antenna?
The piece of coax is about 8 inches long. This wire was way too short to make a direct connection to the Jack. The surface of the roof at this point is just about free of old sealant. Note the existing mounting holes. A dab of Dicor was applied into each hole and allowed to tack up before continuing.
The familiar “Batwing” crank handle is removed using an Allen wrench. Once removed 3 pieces will fall into your hand. Using a #2 Phillips, the detent plate is removed from the ceiling.
How to install a snap and stay lock?
If you’re using the snap and stay bracket, simply snap the outside housing into the hole. 6 Next, orient the slot on the inside thumbturn with the tail piece and secure it to the door using the two self-guiding long screws. The tapered tip of the screws allows them to easily line up and thread.
How to install a deadbolt lock with Schlage?
Here’s how: a. Remove the attachment screw located on the interior side of the outside housing. b. Rotate and remove the bracket. 5 Orient outside housing with Schlage side up, align and insert the tail piece with the bolt. If you’re using the snap and stay bracket, simply snap the outside housing into the hole.
How do you remove a knob from a door latch?
If you’re having problems removing the knob from the latch, you may have to twist it or wiggle it back and forth. You should be able to remove both knobs from each side of the door. Find the screws on the sides of the door handle. Locate all of the screws on both sides of your door handle. Most screws in knobset locks use Phillips head screws.