How do you program a key fob for a 2009 Jeep Liberty?
2009 Jeep Liberty
- Insert First Programmed Key. INSERT a working remote head key into the Ignition and TURN it to the ON/RUN position.
- Remove First Programmed Key.
- Insert Second Programmed Key.
- Remove Second Programmed Key.
- Program Remote.
- Program Additional Remote.
- Exit Programming Mode.
- Test Remotes.
How do you program a key fob for a 2010 Jeep Liberty?
2010 Jeep Liberty Ignition Chip Key Programming Instructions
- Insert the first valid key into the ignition switch. Turn the ignition switch to the ON/RUN position for at least three seconds, but no longer than 15 seconds.
- Insert the second valid key into the ignition switch.
- Insert the new key into the ignition switch.
What to do if your Jeep key fob is not working?
Take a moment and spray canned air in your remote to remove loose debris and dust that might have gathered. Replace the battery, making sure to place the positive side up. Test your remote to see if the battery was the problem by snapping the key fob together and trying it on your car.
Why are my power locks on my Jeep Liberty not working?
Recently my power locks stopped working. I have to manually unlock/lock doors. My key fob does not do anything. Even when I try to unlock doors using lock/unlock button I get nothing. I cannot open rear hatch as it is locked and there is no spot to unlock it with a key.
What to do if your key fob is worn out?
Replace the cover and try the key fob remote on your car again. Check the contacts on the circuitry board for wear. If they are worn, renew the contacts by putting a small amount of condutivity paint on the surface. Allow this to dry, then replace the battery. Snap the cover on and give the key fob a try.
What to do if your Jeep remote is not working?
1. Remove the battery. 2) Use 1/3 of a sticky note, fold it, and place it within the round battery slot (on the floor beneath where the battery is placed. 3) Put the battery in on the folded note. WALAAA! Thank you so much, this worked for me!!! It simply is a problem with the battery positioning within the fab. 1. Remove the battery.
Is there a key fob for a Jeep Liberty?
Since the year 2002 we have been making keys for the Jeep Liberty, by cutting the keys and programming the keys as well as selling key blanks, such as key fobs, and keyless entry remotes. What we have found as the most common problem with Jeep Liberty’s is that people lose or break their keys.
Why does my Jeep FOB not unlock the door?
What is weird is that I usually have this issue after driving the Jeep for awhile and shutting it off for 5 minutes or so, then I can’t get back in unless I hit the unlock button 10-15 times. Sure is embarrassing standing there beside the Jeep not being able to get back in. And if you use the key to unlock the door you set off the alarm! Exactly.
Recently my power locks stopped working. I have to manually unlock/lock doors. My key fob does not do anything. Even when I try to unlock doors using lock/unlock button I get nothing. I cannot open rear hatch as it is locked and there is no spot to unlock it with a key.
What to do if your key fob is not working?
Test your remote to see if the battery was the problem by snapping the key fob together and trying it on your car. If this does not solve the problem, re-open the key fob and clean the contacts. These are the little golden squares on the circuitry board. Place a small amount of isopropyl alcohol on a cotton swab, then rub the contact gently.