How do you install windshield wiper bushings?
How to Install Wiper Linkage Bushings
- Pull the wipers straight out away from the windshield.
- Pull up the screen on the front of the windshield of the vehicle to access the wiper assembly.
- Pop the hood and disassemble the rods and pivots.
- Push the bushings into the rod holes with a pair of pliers.
Where are the bushings on a windshield wiper?
Pull the wiper assembly off and repeat the process for the wiper on the other side. Pull up the screen on the front of the windshield of the vehicle to access the wiper assembly. Locate both the long and short rod along with two pivots and an actuator rod attached to wiper motor shaft.
How do you install wipers on a car?
They are small pieces of plastic that need to be carefully installed for the wipers to work correctly. Pull the wipers straight out away from the windshield. Press down on the tab and slide the wiper outward to remove it from the arm. Repeat the process for the wiper on the other side.
What’s the best way to replace a windshield wiper?
Gently pry the actuator off the shaft, and once everything is free maneuver the entire assembly out of the drain box. It’s a lot easier to work on things if you can see them beneath all the grime, so get rid of it. Clean the wiper linkage assembly. Clean the lower edge of the windshield, the cowl, and the screen.
How do you replace the wiper bushing on a Dodge Caravan?
Just remove the nut, pull off any washer tubes from their fittings on the cowl or pivots, relieve the spring pressure holding the wiper onto its shaft, and pull it straight up and off. Set the wipers aside in a safe place. Unscrew the fasteners. This Caravan has six, three on the outside and three more beneath the hood.
Pull the wiper assembly off and repeat the process for the wiper on the other side. Pull up the screen on the front of the windshield of the vehicle to access the wiper assembly. Locate both the long and short rod along with two pivots and an actuator rod attached to wiper motor shaft.
They are small pieces of plastic that need to be carefully installed for the wipers to work correctly. Pull the wipers straight out away from the windshield. Press down on the tab and slide the wiper outward to remove it from the arm. Repeat the process for the wiper on the other side.
How do you change the arm of a windshield wiper?
Step 1: Turn the wipers on and stop them mid-way up the windshield. Mark their location with the wax crayon. Step 2: Remove the plastic cover over the nut holding the wiper arm onto the post. If possible, simply twist the cover off. If it resists, you may need to use the flathead screwdriver to pry it off.
How do you replace a windshield wiper blade post?
Clean the ridges on the splined wiper blade shaft. A dirty wiper blade post can lead to the failure of the wiper arm. Step 2: Lubricate the wiper post. Apply a couple of drops of oil or a light coating of WD-40 to the wiper blade post; this will make installing the wiper arm easier.