How do you change transfer case fluid in Jeep Wrangler?
There are a couple of ways to find out. The first and most difficult would be to remove the transfer case, crack it open, and inspect the internal components. That’s a lot of work for not being sure if there is even anything wrong inside. The second is to drain the fluid and inspect it for metal shavings and sludge.
How much oil does a Jeep Wrangler take?
Jeep Wrangler JK Fluid Capacities Component Quantity Fluid Type 3.8L Engine Oil 6 Quarts / 5.7 Liters 5w-20 3.6L Engine Oil 6 Quarts / 5.6 Liters 5w-20 Brake Fluid Fill to Full Mark DOT 3 Clutch Fluid Fill to Full Mark DOT 3
What kind of fluid does a transfer case use?
Valvoline has a synthetic fluid made just for transfer cases that meets ATF 4 requirements which is what I refilled the transfer case with. It only took about 30 minutes start to finish to have confidence in the condition of the transfer case. I also now know the fluid is changed instead of wondering if it was ever done in the Jeep’s history.
What kind of fluid does a Jeep Wrangler use?
Jeep Wrangler JK Fluid Capacities Component Quantity Fluid Type Clutch Fluid Fill to Full Mark DOT 3 Power Steering Reservoir Fill to Full Mark ATF 4 3.8L Cooling System 13 Quarts 50/50 Antifreeze/Water Mix 3.6L Cooling System (2013-2018) 10.5 Quarts 50/50 Antifreeze/Water Mix
When to change transfer case fluid in Jeep Wrangler?
Change transfer case fluid if using your vehicle for any of the follow- ing: police, taxi, fleet, or frequent trailer towing. 60K miles. Inspect every 30K. The manual states no need to change the fluid for the life of the vehicle. What does everyone think ?
When did the Jeep Wrangler transfer case come out?
Modern transfer case models: Jeep has produced a large variety of transfer cases throughout the years, but in 2003 the NV241OR or Rock-Trac was released and provided a significant leap in transfer case gearing, allowing Wranglers to run a 4:1 low-range gear ratio from the factory and a tremendous amount of torque while out on the trail.
What are the oils and fluids in a Jeep Wrangler?
Oils and fluids are critical components used to lubricate and cool various mechanical parts of your Jeep. Over time and use, the composition of these oils and fluids breakdown.
What happens when you replace transfer case fluid?
When the fluid is replaced, pay careful attention to the fluid you are draining; if there is a burnt smell or dark brown color or metal flakes or sheen, your transfer case may be damaged. Transfer case fluid is responsible for keeping the components of the transfer case well lubricated.