How do I run schematics in PSpice?

How do I run schematics in PSpice?

Launch “PSpice Schematic Student” by left-clicking your mouse on “Start—PSpice Student— Schematics”. PSpice Schematics will launch and you see the following interface. 2. Click on menu File—New, a new blank schematic sheet will appear as below.

What is voff in PSpice?

Voff is the DC offset value. It should be set to zero if you need a pure sinusoid. Vamplitude is the undamped amplitude of the sinusoid; i.e., the peak value measured from zero if there were no DC offset value. FREQ is the frequency in Hz of the sinusoid.

What is non inverting op amp?

A non-inverting op amp is an operational amplifier circuit with an output voltage that is in phase with the input voltage. Its complement is the inverting op amp, which produces an output signal that is 180o out of phase.

How do you create a netlist in PSpice schematics?

Lab 5-1: Creating a Text Netlist

1. From within OrCAD Capture or PSpice A/D choose File – New – Text File.
2. Type in the netlist for the schematic below.
3. After entering the netlist description add a .
4. Add a library call for nom.
5. Add an AC sweep analysis specification.
6. End the file with an .
7. Save the file as CLIP_NL.

What is an inverting amplifier?

An inverting amplifier takes an input signal and turns it upside down at the op amp output. When the value of the input signal is positive, the output of the inverting amplifier is negative, and vice versa. The amount of amplification depends on the ratio between the feedback and input resistor values.

How do op amps connect to circuits?

1. Step 1: Attach power supply positive, negative, and ground.
2. Step 2: Connect terminals to breadboard nodes.
3. Step 3: Install Op Amp.
4. Step 4: Attach Power to Op Amp.
5. Step 5: Wire Input Signal from Function Generator.
6. Step 6: Inserting Resistors.
7. Step 7: Wire Oscilloscope to Circuit.

What is Vpulse in PSpice?

A voltage pulse or pulse train can be applied as an independent source in PSPICE using the VPULSE element. VPULSE has seven parameters that describe its shape as shown in figure 1. Note that the voltage input is a single 1-volt pulse that is 1 second in duration.