How do I get my catalyst ready for inspection?
So, in order to make the status of catalyst monitor ‘ready’, you need to follow these simple steps.
- Make Sure the Engine Light is Off.
- Check if your Vehicle has a Coolant Temperature.
- Let the Engine be Idle for 2 Minutes.
- Drive the vehicle at a Steady Speed of 55 MPH.
- Decelerate your Vehicle’s Speed at 20 MPH.
- Again Speed Up.
What should I do about my Honda Odyssey?
Performed Honda Service Bulletin 11-038 to eliminate Popping, Knocking, or Creaking in the Front While Turning at Low Speeds. Lubricated strut with silicone grease. Replaced power steering pump and kit. Replaced the front shocks/struts and rear shocks/struts.
What kind of suspension system does Honda Odyssey have?
280-horsepower 3.5L V6 9-speed shiftable automatic FWD Vehicle was delivered with steering wheel slightly turned to the left in order to drive straight. Dealer re-aligned the tie rods and vehicle now drives straight. 248-horsepower 3.5L V6 w/DoD 6-speed automatic FWD Alignment system was broken.
What’s the problem with the Honda Odyssey steering?
Applied new grease to top of struts as per TSB. Clicking/popping noise at low speeds when turning wheel at low speeds. Fixed with SB 11-038. Popping and clicking returned while turning at low speed. Fixed with SB 11-038. Squeaking, creaking, and clicking noise returned to the steering. Lubrication applied and stopped the noises.
How to check the drive cycle on a Honda?
The Honda Drive Cycle is included in recent owners manuals. You can either use an OBDII scanner or, if one is not available, check the MIL (check engine light) because Honda/Acura will indicate, on vehicle startup of the readiness monitors are set. When you turn the ignition to On-2 without starting the engine, the MIL will come on for 20 seconds.
How to test the Honda Odyssey drive cycle?
The ECU will once again self-test the EGR System, EVAP Purge System and Long Term Fuel Trims. ACCELERATE: Go ahead and accelerate again at 3/4 throttle until 55-60mph is reached. This will perform the same self tests as during the first acceleration step. HOLD STEADY: Hold steady speed once again.
How much does it cost to have Honda Odyssey Engine hesitate?
Our certified mobile mechanics can come to you now. Honda Odyssey Engine hesitates during acceleration Inspection costs $89 on average. It can be frustrating for any driver to expect certain acceleration from their vehicle only to find that the vehicle seems to be hesitant while speeding up.
What should fuel temp be in Honda Odyssey?
Perform acceleration steps only on highways) COLD START: Begin from Cold Start, and ignition in OFF position for at least 1 hour. Insure your Honda’s fuel tank is between 1/4 and 3/4 full and engine coolant temperature must be below 122°F and within 11°F of the ambient air temperature.
What do you need to know about Honda Odyssey cold start?
COLD START: Begin from Cold Start, and ignition in OFF position for at least 1 hour. Insure your Honda’s fuel tank is between 1/4 and 3/4 full and engine coolant temperature must be below 122°F and within 11°F of the ambient air temperature. Do not leave the key on prior to the cold start or the heated oxygen sensor diagnostic may not run.