How can I remove a trouble code from a Mazda?
Disconnect battery ground cable for a minimum of 10 seconds, then depress brake pedal five times to clear trouble code’s stored in the memory. Connect SST (NGS) tool to data link connector 2. Then select “Clear Diagnosis Codes” function and erase diagnostic trouble codes from the NGS memory.
How does trouble code work on Mazda B2200?
0.4 second flashes indicate the ‘units’ of the trouble code A 1.6 second pause (MIL OFF) separates ‘TENS’ and ‘UNITS’ Depress the brake pedal for a minimum of 5 seconds Jump test connector (green, 1 pin) to ground Image 1 [1] Connect LED test lamp between DLC terminals Image 1 [2] Switch ignition ON.
When does the number 2 start on a Mazda code?
For example, if the light blinks two times and then pauses, the first number of the code is 2. After the check engine light pauses, the start of the second digit generation has begun.
How to get Mazda codes obd1-2carpros?
Step 1 – Start the engine and allow to warm up to operating temperature, then turn the engine “OFF”. Step 2 – Next, install a jumper wire from the TEN terminal to the GND terminal, located either under the dash or hood depending on model. Step 3 – After the jumper wire has been installed, turn the ignition key to the “ON” position.
0.4 second flashes indicate the ‘units’ of the trouble code A 1.6 second pause (MIL OFF) separates ‘TENS’ and ‘UNITS’ Depress the brake pedal for a minimum of 5 seconds Jump test connector (green, 1 pin) to ground Image 1 [1] Connect LED test lamp between DLC terminals Image 1 [2] Switch ignition ON.
Step 1 – Start the engine and allow to warm up to operating temperature, then turn the engine “OFF”. Step 2 – Next, install a jumper wire from the TEN terminal to the GND terminal, located either under the dash or hood depending on model. Step 3 – After the jumper wire has been installed, turn the ignition key to the “ON” position.
How to find the trouble code on a Mazda?
Ensure ignition switched OFF. Jump test connector (green, 1 pin) to ground Image 1 [1] Connect LED test lamp between data link connector (DLC) terminals 1 and 2 Image 1 [2] Count LED flashes and compare with trouble code table 1.2 second flashes indicate the ‘tens’ of the trouble code 0.4 second flashes indicate the ‘units’ of the trouble code
What does code 0120 mean on Mazda OBD 1?
No short flashes in a group indicate ‘0’. For example: Trouble code 0120 displayed Fig. 3 . Switch ignition OFF. Rectify faults as necessary. Ensure ignition switched OFF. Disconnect battery earth lead for at least 30 seconds. Depress brake pedal for at least 20 seconds. Reconnect battery earth lead.