Does a manual transmission need a flush?
Unlike the automatic however, where you actually have to flush the fluids with a machine for preventative maintenance. The manual requires a simple, in comparison, drain and fill of the transmission fluid. Most manufacturers recommend that manual transmission fluid be changed every 30,000 to 60,000 miles.
Where is the drain plug on a Jeep JK Wrangler?
NOTE: You can also create a drain plug removal tool by cutting the end off of a 17mm allen wrench or H17 bit. 1. Park your Jeep JK Wrangler on level ground. Place an oil catch pan underneath your NSG 370 manual transmission and then, using an H14 allen bit, remove the fill bolt which is located on the passenger side as shown. 2.
How to change the transmission on a Jeep Wrangler?
Using your cut down H17 allen bit or modified coupling nut and 17mm or 11/16″ wrench, reinstall the drain bolt onto your NSG 370 manual transmission. 7. Attach a bottle pump to your Mopar transmission fluid bottle, insert the feeder tube into the side of your NSG 370 manual transmission and then begin pumping the fluid into it.
When to change transmission fluid on JK Wrangler?
Changing your Jeep JK Wrangler’s transmission fluid will give you an opportunity to inspect the magnetic drain bolt for any signs of abnormal wear going on inside (i.e. large chunks of metal attached to it) and new fluid will help keep things operating smoothly.
How often do you change the transmission fluid?
Older transmissions required a change of fluid at regular intervals, usually every 20,000 miles (32,186.88 km). Consult your car owner’s manual or vehicle repair manual for the recommended lubricant for your manual transmission and, if necessary, the fluid change interval. You may replace the transmission fluid yourself at home, if necessary.
NOTE: You can also create a drain plug removal tool by cutting the end off of a 17mm allen wrench or H17 bit. 1. Park your Jeep JK Wrangler on level ground. Place an oil catch pan underneath your NSG 370 manual transmission and then, using an H14 allen bit, remove the fill bolt which is located on the passenger side as shown. 2.
How to change manual transmission on Jeep JK Wrangler?
Hold an oil catch pan up close to the exhaust crossover on your Jeep JK Wrangler and then remove the drain bolt completely. 4. The drain bolt on your NSG 370 manual transmission has a tip that is magnetized and as you can see in this pic, it should be covered with small metal filings that stand up like hair.
Where is the oil catch pan on a Jeep JK Wrangler?
Park your Jeep JK Wrangler on level ground. Place an oil catch pan underneath your NSG 370 manual transmission and then, using an H14 allen bit, remove the fill bolt which is located on the passenger side as shown. 2.
How to fill Mopar Fluid in Jeep NSG 370?
Attach a bottle pump to your Mopar transmission fluid bottle, insert the feeder tube into the side of your NSG 370 manual transmission and then begin pumping the fluid into it. It should take just a tad over 2 quarts of fluid to fill and you’ll know when it’s full when fluid starts to ooze back out the fill hole. 8.