Do you need to replace the nose drive on a supercharger?
The overhauled nose drive comes with everything you need to replace it, the nose drive, oil, a new shaft coupler, and the needed sealant for the casing.
Can a bearings be removed from a supercharger?
Placing load on the outer race may cause damage to the bearing. Try to place all your support on the shaft itself and not on the end bearings during installation of the remaining 2 bearings which seat against their respective gears. Input seal can be removed with a socket that fits between the ID and OD.
Where is the coupler on an Eaton supercharger?
The supercharger coupler will be located right on the pins of the supercharger. Just take out the old coupler and replace it with the new one. Once the coupler is installed you will want to make sure the supercharger nose cone and supercharger main body is clean of any silicone.
Can a nut be removed from a supercharger?
An impact gun is highly recommended for this operation. If you don’t have access to an impact gun, do not bother attempting this rebuild on your own, you will only damage your supercharger. The nut can actually be removed while the housing is still on, but you get better access to the nut without the housing in the way.
How to replace bearings and seals in a supercharger?
Bolt is a standard right- hand thread. • Be sure to remove key once pulley has been removed. • Remove the 10 bolts which secure the front cover to the gear case. • With care and patience, remove the front cover. There are two dowels which align the front cover to the gear case.
The supercharger coupler will be located right on the pins of the supercharger. Just take out the old coupler and replace it with the new one. Once the coupler is installed you will want to make sure the supercharger nose cone and supercharger main body is clean of any silicone.
An impact gun is highly recommended for this operation. If you don’t have access to an impact gun, do not bother attempting this rebuild on your own, you will only damage your supercharger. The nut can actually be removed while the housing is still on, but you get better access to the nut without the housing in the way.
How do you change oil in a supercharger?
• Remove oil feed pipe. (Not necessary) • Remove oil drain fitting. (Not necessary) • Mark compressor housing relative to the gear case. Score the housings with a chisel or use a paint pen (sharpies may rub off when cleaning the housings). • Remove the 6 bolts and e brackets which secure the compressor housing onto the gear case.