Can a small block engine be swapped for an LS engine?
Unfortunately LS engines don’t just simply bolt in place of a traditional small-block or big-block. While they are similar in size, the engine mounts are different. With the ever growing popularity of swapping LS engines into classics, there are a lot of options for engine mounts.
Can you swap LS6 heads for LS4 heads?
Bolting a set of LS6 heads to the iron block, the LQ4 was born. The 1999 and 2000 model year engines had cast iron heads with all other model years sporting the cast aluminum heads. The beefy iron block and the 4.000-inch cylinder bores that can accommodate the GM L92 heads make for some serious horsepower at budget prices.
Can a bad crankshaft seal cause an oil leak?
All manufacturers have a recommended service interval for most of the components on a vehicle. Servicing the crankshaft seal according to the recommended service interval can prevent the seal from failing in the first place, which can cause other problems. Oil leaks are the most common symptom of a problem with the crankshaft seal.
What’s the difference between an LS and a LQ4 engine?
Based on the LS engine, this 6.0-liter truck engine was designed to bridge the gap between the new LS small-blocks and big-blocks for the truck applications. The major difference in the LQ4 engine is that they are cast iron instead of aluminum. Bolting a set of LS6 heads to the iron block, the LQ4 was born.
What causes H line shocks when switching takes place?
H Line Shocks when Switching Takes Place As 4 A 5. the line system storage volume is excessive lines loose 1. switches too quickly 2. restrictors or orifices damaged I Pump Switches on and off too Often 1. pump defective 2. in the case of accumulator installation, the pump is too small Sequence valve or shut off valve has wrong setting
What does it mean when a hose blows off in a car?
When the hose blew off, it sprayed dye all over the inside of the engine bay near the condenser connection. Does this mean that I lost oil along with refrigerant and need to evacuate the system completely to measure and add more oil?
What to do if hydraulic oil starts leaking?
Check to see that oil intake is well below surface of oil in reservoir. Check pump packing and line connections on intake side by pouring hydraulic oil over suspected leak. If noise stops]
Do you need to worry about the oil level in the system?
My question now is, do I need to worry about the oil level in the system since the hose blew off or should I be ok? The compressor was pre-oiled with enough for the entire system and I added UV dye to the low pressure fitting on the compressor before attaching the hoses.