Can a broken turn signal on a Harley Davidson be fixed?
This article applies to the Harley Davidson Touring. A busted or erratic turn signal repair can be a drag to fix, especially on the road. It’s not a showstopper because you can still ride. But turn signals are an essential part of bike safety. Hand signals are fine during the day, yet are hard to see at night.
Is it illegal to not have a turn signal on a bike?
It’s not a showstopper because you can still ride. But turn signals are an essential part of bike safety. Hand signals are fine during the day, yet are hard to see at night. A broken signal light is illegal in many states. So, don’t let this problem persist. Get those signals fixed as soon as you can.
What to do when your turn signal doesn’t work?
Turn the ignition to run/stop in run position with ignition off. Hold ODO reset button in and hold. Turn ignition switch to IGN. Release ODO reset button. Background should light up, speedometer needle should sweep its full range and indicator lamps (battery, security, low fuel, check engine and cruise) should all light up.
How can I tell if my turn signal is current?
To determine if a code is current or historic, you must clear the displayed code by pressing in and holding the ODO reset button for over five seconds until “clear” is shown in the display. Release the ODO reset button and turn off the ignition switch.
This article applies to the Harley Davidson Touring. A busted or erratic turn signal repair can be a drag to fix, especially on the road. It’s not a showstopper because you can still ride. But turn signals are an essential part of bike safety. Hand signals are fine during the day, yet are hard to see at night.
It’s not a showstopper because you can still ride. But turn signals are an essential part of bike safety. Hand signals are fine during the day, yet are hard to see at night. A broken signal light is illegal in many states. So, don’t let this problem persist. Get those signals fixed as soon as you can.
Turn the ignition to run/stop in run position with ignition off. Hold ODO reset button in and hold. Turn ignition switch to IGN. Release ODO reset button. Background should light up, speedometer needle should sweep its full range and indicator lamps (battery, security, low fuel, check engine and cruise) should all light up.
To determine if a code is current or historic, you must clear the displayed code by pressing in and holding the ODO reset button for over five seconds until “clear” is shown in the display. Release the ODO reset button and turn off the ignition switch.
Why is my hazard light not working on my Harley?
Check the hazard light box and make sure all signal wires are attached. Check the flasher for functionality (turn signal relay). The wiring for the turn signal lights goes through the turn signal switch. This means that the turn signal switch may be bad. If only one light (or one side) isn’t working, check the power to the bulb plug-in connections.
How do you put LED lights on a Harley Davidson?
Putting LED lights on a Harley Davidson usually requires that you install a load equalizer on the line. A load equalizer brings the load to the same level as two incandescent bulbs, so the system thinks that everything is okay. Check for a bad bulb: check all the bulbs for any burnt ends and replace them.
Where does the flasher go on a Harley Davidson?
Check the flasher for functionality (turn signal relay). The wiring for the turn signal lights goes through the turn signal switch. This means that the turn signal switch may be bad.