Why wont my indicators work on my motorbike?
Your new bulbs might not draw enough current. One of your wires could be reversed or grounded. Your flasher wire could be faulty or not connected at all. You’ve blown a fuse.
What should I do if my indicator light is not working?
To replace the relay (it’s one unit, but contains two separate relays – indicator relay flasher and hazard) you will probably be better off by removing the stereo to get a good grip on the panel that covers the top part of the central console (cup holder, ESP buttons and hazard button/relay).
What causes the indicator lights to stop flashing?
All indicator bulbs have stopped flashing but the dashboard lights are flashing but faster than usual. When the hazard Car was centrally locked and alarm set. No previous issues. Horn came on on its own. It wasn’t the usual intermittent to… Dashboard instruments not working. Blown fuse 33
What should I do if my Audi indicator is not working?
In any case, carefully lever off the panel from the bottom and then pull the panel slightly up and towards you. It’s held in with clips, so be careful not to damage any of them. The next part is a little fiddly, but you will need to get a flat screwdriver in the corner of the hazard switch and lever it out of place.
How much does a flasher relay replacement cost?
Hi mate, the flasher relay replacement is a 15 minute job if you have all the needed tools. Go to Stoke Audi section on here and request the part from Dave. Given a chassis number he can give you the correct part. I think it’s in the region of 25 pounds, so not too big of a deal.
Why do indicators don’t flash, relay changed where to look?
Replaced the fuse, all is OK except indicators come on but don’t flash, just stay illuminated. Been & changed the relay, same result, changed it again incase replacement was dud, same again. Bulbs light so they are ok, wiring working becasue of current to bulbs. Where else do I look???
To replace the relay (it’s one unit, but contains two separate relays – indicator relay flasher and hazard) you will probably be better off by removing the stereo to get a good grip on the panel that covers the top part of the central console (cup holder, ESP buttons and hazard button/relay).
Why does my relay only turn on 5V?
This could mean if you are powering from the 5V adapter, the current required to operate the relay is not enough and it only turns on the LED or the driver. Chances are your supply is of not enough capacity .Try to change it to something 5V 2A / 5V 4A A better option is to power the relay with its own dedicated supply.
Where do I find the turn signal relay?
Locate the turn signal relay. This should also be in your owner’s manual. If it’s not, you can consult a service manual for your car. Once you can see your relays, remove the old turn signal flasher relay and replace it with the new one. Don’t worry about installing it incorrectly, it will only go in one way, the right way.