Why is there an error code on my air conditioner?
There is usually not enough water in the drain pan to cause the air conditioner to shut off. If the P2 or FL error code is displaying on the air conditioner, remove the drain port cap and tilt the air conditioner to the back so the water runs out of the drain outlet.
What to do if your air conditioner has a P2 error code?
Unplug the air conditioner, leaving it unplugged for at least 10 seconds. Press the POWER button to turn the air conditioner back on. If the P2 or FL error code appears after performing a reset. The unit will require a repair service.
How to find carrier split air conditioner error code?
Carrier Split Air Conditioner 38GVM Error Code Chart Below: Carrier Split Air Conditioner 38GVM Error Codes Chart Note: Different unit sizes may have different error code definitions, check the list carefully below to find the SIZE of your Carrier AC and then your error code.
How to delete a / C Diagnostic Trouble Codes?
Proceed to ERASING DIAGNOSTIC TROUBLE CODES. 1) After display window shows “En° d”, press AUTO push button once again. Display window should show “dE L” (delete). 2) To erase DTCs, simultaneously press down and up arrow push buttons for more than 5 seconds. The display window should show “- –“. If not erasing DTCs, press the AUTO push button.
What to do if you get an error code on your room air conditioner?
An error code on the display of the room air conditioner can usually be resolved by performing a few simple troubleshooting steps. If you need information about a split unit or duct free air conditioner, they are considered business units, please visit www.lg-dfs.com for further support.
Why do I get an error code on my carrier AC?
When error codes appear on your Carrier AC, this tells the user there’s a problem with the Carrier AC with either the inside wall unit or outside unit. The error code that is displayed will tell you the problem that is occurring within the air conditioner.
Proceed to ERASING DIAGNOSTIC TROUBLE CODES. 1) After display window shows “En° d”, press AUTO push button once again. Display window should show “dE L” (delete). 2) To erase DTCs, simultaneously press down and up arrow push buttons for more than 5 seconds. The display window should show “- –“. If not erasing DTCs, press the AUTO push button.
What does error code 24 mean on furnace?
Answered in 6 minutes by: 12/10/2016 HVAC Technician: airheatman, HVAC Technician replied 4 years ago airheatman, HVAC Technician Category: HVAC Satisfied Customers:15,729 Experience: Furnace, A/C and heat pump specialist. Verified Error 24 and blank display tells us the small fuse on control board is blown: