Why is the speedometer on my Freightliner not working?
Earlier we did go through the trucks wiring systems, took the whole dash off, underneath as well when looking what could have caused the ZF Meritor to malfunction. Thanks! Every month 400 people find a job with the help of TruckersReport.
Is there a warranty on Freightliner speed sensor?
In addition, Raney’s will not be liable for any incidental or consequential damages and your exclusive remedy shall be replacement of the product that did not comply with this limited warranty. Click the button below to add the Freightliner Speed Sensor SAA85920008 to your wish list.
What kind of engine does a Freightliner Columbia have?
I have a 2006 freightliner Columbia with mbe4000 engine and 12 speed smart shift. 48,000 miles. Going down highway check engine light came on,cruise kicked out, trans stuck in 12th gear. Pulled off ro…
What to do when you get a fault code on a Freightliner?
Turn the ignition key ON but do not start the engine. If the engine is already running, you may still retrieve codes, however, do not engage the starter if engine stalls. 4. To Retrieve Active Codes: Start with the key in the ON position.
How tall is the Argosy cab on a Freightliner?
DIMENSIONS ARGOSY Cab type, 6 x 4 BBC (mm) OA Cab Height (mm)* 90” sleeper 2,271 3,508 101” sleeper 2,582 3,508 2,822 3,508 110” RR sleeper 2,822 4,150 * For 282.6 mm rail, 11R22.5 tyres and Freightliner AirLiner 46K, excludes aerodynamic equipment
How can I tell if my Freightliner solenoid is defective?
What you have is a bad solenoid. It can be found with your fuse panel. With the key on take a test light ground it and check for 12 volt power at the solenoid. There should be two cables on the solenoid. You should have 12 volts on both sides of the solenoid if not then your solenoid is defective.
How can I tell if my Freightliner instrument cluster is defective?
With the key on take a test light ground it and check for 12 volt power at the solenoid. There should be two cables on the solenoid. You should have 12 volts on both sides of the solenoid if not then your solenoid is defective. When you get a replacement be sure that it is a 12 volt continuous duty solenoid of adequate amp capacity.
https://www.youtube.com/watch?v=FSmJrKHZ_0k