Why is the 4×4 warning light not working?
The DSC button has no effect on the 4×4 light, which stays on. Hill Descent does not work. So judging from previous posts, I need to pull codes now. It could be a wheel sensor, the steering angle sensor, yaw sensor, or the transfer case worm gear bit.
Why is my 4 wheel drive light not engaging?
If you don’t shift it into neutral, the 4wd light will continue to flash and won’t get into gear. Seems to be a common occurrence on these trucks. Dodge dealers recommend engaging 4-lo, then back in 2-wheel drive, then back in 4-wheel drive hi (4H). This sequence apparently resolves the problem.
What does the blinking 4 wheel drive indicator mean?
So what is that 4 wheel drive indicator blinking on your dashboard means? The purpose of the 4 wheel drive light is to indicate when you have engaged 4WD mode by selecting 4H. When the light flashes continuously for more than 30 seconds it signifies there is a problem somewhere on your drivetrain system and that 4WD has not engaged properly.
Why is the 4×4 traction control light off?
Get in the car today and the “4×4! light is off.. traction control engages/disengages like normal.. no hills in flatland florida to try out the DHA today.. Whatever is causing the sytem to shut down is an intermittent problem which should make this even more fun to diagnos…
Why is the 4 wheel drive indicator light not working?
The “Service 4X4” indicator light stays on and my vehicle is stuck in 4 wheel drive. Any suggestions? The fan switch on my 1999 Tahoe seems to work only when Hi is selected, although there are occassions when dropping down to Med-Hi that fan still runs and sounds as though there is no change in fan speed.
How does a 4 wheel drive light work?
It accomplishes this by means of a small electric motor bolted onto the transfer case that shifts a pin in place to lock the center transfer differential. The actuator allows you to shift from 2WD to 4WD on the fly and back to 2WD without stopping and can be engaged and disengaged by means of a switch inside the cabin, usually on the dashboard.
Where are the 4×4 lights on a Ford Ranger?
No 4×4 lights at key on, No click when switch is turned = 4×4 Control module – under passenger side kick panel interior. Just fixed my 2002 xlt ranger. For the lack of one shift lever sticking through the floorboard.
Is it possible to reset the warning lights on the dash?
This will result in a warning light appearing on your vehicle’s dashboard. After the repair is complete, however, it may still be necessary to reset your the computer in order for the warning light or lights to disappear. Fortunately, this process is fairly simple. Open the hood of your vehicle.