Why is my MaxxForce crank but no start?
I also heard that using cheap fuel filters causes issues. They are all expensive and hard to find American made filters. Foreign made junk should cost end users less but it usually cost you more in other areas. Like a cheap air filter that a contractor installed. It somehow got rain water intrusion and sucked part of the filter into the engine.
Why does my MaxxForce DT have low power?
If the egr valve is sticking open slightly hard start will occur but the engine will also have low power. The air management test often finds this problem. Fuel pressure must be to spec for the year of engine you have. It can be measured at the test port on the intake manifold on epa 2007 through current design.
Where is the oil pressure regulator on a MaxxForce 9?
If you engine is a MaxxForce 9, the oil pressure regulator is on top of the oil filter housing. What codes do you have? What codes do you have? I wish I could give you that info but I have yet to dig into what I’ll need puter wise for these things.
What kind of bus has MaxxForce DT466 in it?
2008 IC CE300 with Maxxforce DT466 with 95k on the clock. Morning route bus starts as it should. Afternoon route bus starts as it should. I noticed problem after bus was parked for fuel after a route.
What makes an international MaxxForce DT No start?
Sounds different when cranking as well. Will not even start on starting fluid, not even a little bit. It does not build oil pressure while cranking. Codes are engine exhaust valve actuation system oil pressure, brake switch, and engine turbocharger 1 outlet pressure. SPN 4287, SPN 5541 and SPN 597.
What kind of engine does MaxxForce school bus use?
It somehow got rain water intrusion and sucked part of the filter into the engine. After replacing the engine and solving his bad filter housing issue – all is well 20,000 dollars later. Cummins engines, Columbus, IN., world headquarters, American company, are installed in most all our new buses. MaxxForce Engines are a maxx.,expense money pit.
What is SPN 731 code on MaxxForce 13?
It’s the dreaded SPN 731 code but is the FMI 18 or FMI 16. Two different paths for diagnostics depending on the exact fault. You can start blindly throwing parts at it if you want but I doubt you’ll fix it without doing the diagnostics.