Why is my Harley lights flashing?
If you’ve got a Harley-Davidson equipped with a security system, your motorcycle’s motion sensors are going to trigger the alarm when it senses that it’s being moved. After 600 miles or so in the back of that trailer, all those blinking lights will have run your battery dry.
How do I reset my Harley-Davidson security system?
Can’t read Harley Davidson codes
- Turn off the ignition.
- Press/hold the odometer reset button.
- Turn on the ignition, and then release your hand off the odometer reset button.
- After you release the reset button, the background and indicator lights will turn on.
- Again, press the RESET button.
How do I know if my Harley has security?
Registered. One way to tell for sure is to determine whether your bike has a Turn Signal Module(TSM) or a Turn Signal Security Module(TSSM) installed. TSM = no security system TSSM = security system. On the side of the module there should be a sticker with a H-D part number.
Why is the blinker on my Harley Davidson not working?
If only one light (or one side) isn’t working, check the power to the bulb plug-in connections. With a voltmeter or test light, check the terminals for power. Check the battery for a full charge. Figure 1. Multimeter. Also consider what kind of work was recently done on the bike that might have affected the blinker system.
Why is my hazard light not working on my Harley?
Check the hazard light box and make sure all signal wires are attached. Check the flasher for functionality (turn signal relay). The wiring for the turn signal lights goes through the turn signal switch. This means that the turn signal switch may be bad. If only one light (or one side) isn’t working, check the power to the bulb plug-in connections.
Why does my badlander turn signal not flash?
Installed a badlander load equalizer 17 years ago for run and brake lights on the rear. If the bike is not moving the right turn signal functions correctly. If bike is moving, if you press the right turn signal, it will light up, but not flash. Looked in the service manual and this problem is not listed for troubleshooting the turn signals.
Why are my turn signals not flashing on my Harley Davidson?
If you are stuck with having to manually cancel the turn signals, the problem could be found in connectivity to the speedometer or the TSSM. Check the switches. Check for loose or disconnected wires to the speedometer. Check the tip switch that cancels if the bike falls over.
If only one light (or one side) isn’t working, check the power to the bulb plug-in connections. With a voltmeter or test light, check the terminals for power. Check the battery for a full charge. Figure 1. Multimeter. Also consider what kind of work was recently done on the bike that might have affected the blinker system.
Why do the lights keep flashing on my Harley Davidson?
It’s when the fob is out of range and the bike is “disturbed” a bit and the security activates by flashing the lights like it is supposed to do but the dang lights just keep flashing till I get my fob out of the house and take it close to the bike. Have you tried to turn off the security system and turn it back on.
Installed a badlander load equalizer 17 years ago for run and brake lights on the rear. If the bike is not moving the right turn signal functions correctly. If bike is moving, if you press the right turn signal, it will light up, but not flash. Looked in the service manual and this problem is not listed for troubleshooting the turn signals.
Why are my turn signal lights not flashing?
My Harley Heritage Softail 1996 indicator/turn signal lights stay on when instead of blinking. I hit the “turn” button for the signal/turn lights, but they just come on and stay on!