Why does the engine light come on on my Toyota RAV4?
The VSC, 4wd, and engine… The VSC, 4wd, and enginelight came on after we put in gas. We have tried a new gas cap. After taking off the positive side of battery off but after about three times of shutting off and restarting engine the lights come on again.
What is the OBD code for a Toyota RAV4?
Sounds like the parts place she went to used a high end professional scanner that reads more than just OBD codes. OK NOLAgirl, the C1249 is an open in the stop light switch circuit. This could be as simple as a bad brake light switch on your brake pedal. The C1201 code is Engine Control System Malfunction.
What does the code c1201 mean on a Toyota RAV4?
The C1201 code is Engine Control System Malfunction. This is kind of a generic code that says something else is wrong. It could be caused by the C1249. The C1223 is ABS Control System Malfunction. This definitely has to do with the C1249. And finally, the B1810 says that there may be a short in the driver’s side airbag. Is your airbag light on?
How to check engine, VSC and traction control?
This evening I heard an odd rattle and looked down to the dash and had 3 lights on- Check Engine, VSC and Traction Control. Car was still running. When I stopped the car, turned the engine off and then turned it back on (no problem) all 3 lights stayed on.
Can a Toyota RAV4 drive with the VSC light on?
Yes, you can drive with the VSC light on. Your Toyota Rav4 will run and drive completely normal. You do need to be aware that the vehicle stability control system is an important safety feature. Ignoring the problem for a prolonged period of time is not advised.
How does the hill assist work on a Toyota RAV4?
Downhill assist control system. Hill−start assist control system. The light will come on when the engine switch is turned to the “ON” position and will go off after a few seconds. If the light comes on while driving, all the above systems will not work.
When do the VSC off and check engine lights come on?
“VSC Off” and “VSC TRAC” lights will often come on when an error code triggers the Check Engine light. It doesn’t necessarily mean there is an issue with those systems. If they all showed up at the same time, it’s likely that diagnosing the cause for the Check Engine light will fix them all.
How to check the engine light in a Toyota?
All you need is a short piece of small gauge wire–speaker wire works fine, or even a paper clip bent into a U shape. With the ignition off, place the jumper wire across pins 4 and 13 of the diagnostic port. Now turn the key to ON, but don’t start the engine. With the smart key system, push the button twice with your foot OFF the brake pedal.
What is the OE number on a Toyota RAV4?
The Toyota OE part number is: 894650R020 – most local parts stores can “cross over” or “interchange” this part number to the correct version of the after market brand they carry. Make sure to check the fuses in the dash fuse box and the under hood fuse block (labeled in red in images below).
What does the Check Engine light and VSC mean?
CEL, VSC, and 4WD/TRAC (Check Engine Light, Vehicle Stability Control, and 4-Wheel Drive/Traction Control The CEL indicates that the ECM has stored a diagnostic trouble code (DTC) and means something is not quite right in the engine.
How to clear ABS / VSC codes in Toyota?
If you have ABS/VSC codes and lights, even disconnecting the battery will not clear them. To clear these codes from the Skid Control ECU, take your jumper wire and re-connect it to pins 4 and 13 of the diagnostic port. Now, turn on the ignition and immediately tap the brake pedal 8 or more times.
What do the warning lights on a Toyota mean?
With the smart key system, push the button twice with your foot OFF the brake pedal. The warning lights should now be flashing on the instrument cluster. A light that is flashing regularly means that particular system is normal. A coded flash indicates a problem.
What kind of engine does a Toyota Rav 4 have?
Toyota Model: RAV 4 SR 2.2 D4D 150 in Decuma Grey and Daihatsu Sirion 2008 with Yaris mechanics. Yes it is starting to pop up – Sywy was the first to get it and a mate of mine called the other day with the same thing on his 4.3 which ran out of warranty in March!
What’s the fault on my Toyota 4×4 engine?
It is down to a clogged/sticking EGR valve and records the fault “P0400”. The good news is that Toyota have extended the warranty on this fault to 5 years or 100k miles on parts and labour and the new valve is modified. You need to make your dealer aware so that he can do some digging – they may not be so aware in Romania.