Why does my Nissan Pathfinder keep dying?
The engine can die if the fuel pressure is not high enough to properly atomize the gasoline properly. The fuel pump is often not monitored by the engine’s computer, which means it doesn’t activate the check engine light when you are trying to figure out why the vehicle it is randomly dying.
When do they start paving on Highway 97?
Highway 97. Paving operations between Begg Rd and Maranatha Dr for 39.8 km (31 km north of 100 Mile House to 150 Mile House). Until Fri Jul 30 at 7:00 PM PDT.
When is Highway 97 closed in both directions?
Highway 97, in both directions. Industrial traffic may slow or block regular traffic. Between Homewood Rd and Kloss Rd for 17.0 km (McLeod Lake). Until Wed Jun 30 at 4:30 PM PDT. Road closed intermittently.
Where is the sweeping event on Highway 97?
Road sweeping between Scottie Creek Rd and 26 Mile Frontage Rd for 15.6 km (18 km north of Cache Creek to 4 km south of Clinton). Until Fri Jun 4 at 4:00 PM PDT.
Are there any problems with my Pathfinder truck?
This should be helpful for people browsing the Internet for minor problems/work on their Pathfinder. Updated 1/8/07, added rust details, tension rod problem and edited several inaccuracies. Problems with your fuel and temp gauges are common with the 95 and older trucks.
This should be helpful for people browsing the Internet for minor problems/work on their Pathfinder. Updated 1/8/07, added rust details, tension rod problem and edited several inaccuracies. Problems with your fuel and temp gauges are common with the 95 and older trucks.
Why are the exhaust manifold studs on my Pathfinder breaking?
WD21 Pathfinders with the VG30i and VG30E engines were built with weak exhaust manifold studs that are prone to breaking because the exhaust manifolds tend to expand unevenly when warming up and cooling down.
Why are the torsion bars on my Pathfinder wrong?
The torsion bars have a slow memory. If the vehicle has been on a hoist prior to an alignment, the front end alignment will be incorrect because the front end will be sitting higher than normal. One place went so far as to explain that it could not be aligned because the rear axle was crooked.
What causes the ticking noise on a pathfinder?
This causes the infamous “ticking” noise often heard from the front of Pathfinders which quiets down after the manifolds have heated up sufficiently. This applies to all Pathfinders from 1987 through 1995.