Why does my Harley Davidson battery not charge?
Checked for shorts or opens on stator. Checks ok. Must be the regulator. Replaced the regulator. Same readings, battery still not charging. Checked the stator output again. Still appears to be working. Spoke to Bubbie by phone and he told me that Hoople might have some suggestions.
When did the Harley Davidson Electra Glide Ultra Classic come out?
The Harley-Davidson FLHTCUI Electra Glide Ultra Classic model is a Touring bike manufactured by Harley-Davidson . In this version sold from year 1999 , the dry weight is and it is equiped with a V2, four-stroke motor.
What kind of battery do you need for a Harley Davidson?
If you want a long-lasting motorcycle battery or one that will survive winter, go for a Lithium battery. They take 3 to 5 times as long to lose their charge compared to a lead-acid battery. What’s the best battery for my Harley?
What to do if your Harley Davidson battery is dead?
If your Harley’sbattery is dead then you have come to the right place! This motorcycle battery finder will help you select the right battery for your Harley.
What kind of bike is a 2000 Harley Davidson Electra Glide?
2000 Harley-Davidson Electra Glide ULTRA CLASSIC, This Beauty is a One Owner, Garage Kept Motorcycle with extremely Low miles. You can tell this machine was well loved. Paint, Body, and Leather all in immaculate condition, no cracks or crazing.
Where can I buy a 2000 Harley Davidson?
2000 Harley Davidson, Ultra Classic under 30,000 miles. It has been upgraded with Rush mufflers, high end speakers, new cam & bearings. The tires are in descent shape, I am selling it for my father who lives in Butler, PA, North of Pittsburgh.
What kind of battery does a Harley Davidson use?
Energizer TX20HL AGM Motorcycle and Atv 12V Battery, 310 Cold Cranking Amps and 18 Ahr. Replaces: YTX20L-BS and others . . . Only 13 left in stock – order soon.
What happens if you have a bad voltage regulator on a Harley?
If there is anything wrong with the voltage regulator of your precious Harley, you will notice some unusual behaviors from the bike as follows – As I mentioned earlier, a bad regulator cannot control the voltage, which overcharges the battery. When the battery gets overcharged regularly, it causes the gas to escape from it.
What should I do if my Charger regulator is not working?
Assuming your rectifier part of the unit is still working, you’ll see current flowing to your battery. You will see your battery voltage increasing because it has current flowing into it. If you suspect the regulator part of the unit is not working, you can set your multi-meter to the “DC Volts” setting, generally a 20-volt setting.
What should the voltage be on a Harley Davidson Charger?
Generally speaking, 14.6 volts is a hard set regulation point on most 12 volt systems such as a Harley. Basically, this does not allow the regulator to send voltage to the battery any higher than 14.6 volts. If the stator fails, your battery will no longer be charging when you’re riding your motorcycle.
Checked for shorts or opens on stator. Checks ok. Must be the regulator. Replaced the regulator. Same readings, battery still not charging. Checked the stator output again. Still appears to be working. Spoke to Bubbie by phone and he told me that Hoople might have some suggestions.
How to test the charging system on a Harley Davidson?
Charging System Voltage Test Start motorcycle, measure DC Volts across the battery terminals (you should have a reading of approximately 13.2-15 DC Volts). 3. Check Connections/Wires Inspect the regulator/stator plug, and check the battery terminals for connection/corrosion.
If there is anything wrong with the voltage regulator of your precious Harley, you will notice some unusual behaviors from the bike as follows – As I mentioned earlier, a bad regulator cannot control the voltage, which overcharges the battery. When the battery gets overcharged regularly, it causes the gas to escape from it.
Assuming your rectifier part of the unit is still working, you’ll see current flowing to your battery. You will see your battery voltage increasing because it has current flowing into it. If you suspect the regulator part of the unit is not working, you can set your multi-meter to the “DC Volts” setting, generally a 20-volt setting.
What should the charging voltage be on a Harley stator?
You can use 13 as a good all around battery voltage. That is a good healthy battery staying charged just above 12 volts. Example only: Let’s say the stator is rated for 10 amps x 13-volt battery: 10 x 13=130 watt charging system. So you have a 130-watt charging system in this example.
What to do when your Harley Davidson won’t start?
Try neutral with clutch pulled in. Also battery connections , solenoid wire. The security system lights only flash after I turn off the bike. I have the bike in neutral and I even tried pulling in the clutch a couple of times. I checked the wire to the solenoid and it had power.
What should I do if my battery charger is not working?
Almost certainly it’s a battery problem, either low charge or bad cable connection. Charge the battery on a good bench charger, not a Tender, but a real charger. Remove and reconnect both battery cables making sure they are tight and connections are clean. This sounds like a discharged battery to me just saying.
Why is my Harley Davidson battery not charging?
If the stator fails, your battery will no longer be charging when you’re riding your motorcycle. Often times, a short can happen in the windings around the stator. The insulation on the wires can wear down over time or a wire can break.
How do you close the Charger on a Harley Davidson?
This modal can be closed by pressing the Escape key or activating the close button. Tech review of the Harley Davidson charging system. Here’s an easy way to make sure your battery is charging.
You can use 13 as a good all around battery voltage. That is a good healthy battery staying charged just above 12 volts. Example only: Let’s say the stator is rated for 10 amps x 13-volt battery: 10 x 13=130 watt charging system. So you have a 130-watt charging system in this example.
Try neutral with clutch pulled in. Also battery connections , solenoid wire. The security system lights only flash after I turn off the bike. I have the bike in neutral and I even tried pulling in the clutch a couple of times. I checked the wire to the solenoid and it had power.
Where does the charge lead go on a Harley Davidson?
The battery charge lead runs form the voltage regulator to the positive side of the battery. The AC output lead wire leads from the voltage regulator to the stator.
Can a car charger charge both batteries at once?
In the case with the battery connected to the running vehicle, the alternator is what is charging both batteries. Still, you shouldn’t allow this to go very long without disconnecting as it is a crude way to charge a battery. Remember, we’re not looking to charge the battery.
What should I do if my car charger wont recognize my battery?
With the car running, hook one of the positive ends (red) of the jumper cables to the positive terminal on the bad battery, and then the other positive cable to the positive terminal of the good battery. Then hook the negative (black) end to the good battery and finally the other negative end to the negative terminal of the bad battery.
How can I tell if my motorcycle charging system is working?
So you have a 130-watt charging system in this example. Now, you can take the wattage of all those electrical accessories and see if you’re under or over your 130 watts and how much you have to play with. You can check your system by putting a volt meter on your battery. Or add a volt meter gauge to your motorcycle.
The battery charge lead runs form the voltage regulator to the positive side of the battery. The AC output lead wire leads from the voltage regulator to the stator.
What should I do if my riding mower battery won’t charge?
If your lawn mower battery won’t hold a charge, connect it to the charger. If it isn’t fully charged within 8 hours, your battery is dead and you’ll need to replace it. If your lawn mower battery does charge fully, the charge should not drain if it is not in use. Additionally, why won’t my riding mower charge the battery?
What happens if your car battery is not charged?
If the battery is fully charged, then yes it will, but not for long. If the alternator is not charging the battery, then the car will stall after a short time. You may be able to drive the car a short distance, if you can keep any unnecessary electrical systems turned off. Q.
Why is my lawn and Garden Battery not charging?
Lawn & Garden Battery Not Charging – Fast & Easy Fix! – YouTube Lawn & Garden Battery Not Charging – Fast & Easy Fix! If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
What should I do if my battery is not charging?
Should be 4 or 5 bolts to take the cover off. The part should have a wire or two coming out of it. It’s small and one side of it looks like it has been filled with hot glue. That part takes the spark from the electromagnet and feeds a charge to the battery. The part should be held on the side of the engine with one bolt. Was this answer helpful?
Why is my lawn mower battery not holding a charge?
Lawn Mower battery not holding a charge. Voltage regulator swap. – YouTube Lawn Mower battery not holding a charge. Voltage regulator swap. If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.
What causes a car battery to not start?
Very often, the first sign of battery trouble is when your car won’t start. But how do you tell if it is caused by the car battery not charging, or if it’s something else? A car that won’t start can be caused by a fault with the alternator or some other part of the electrical charging system.