Why does my GM pickup engine not start?

How To Test The Fuel Pump On GM TBI Fuel Systems (for throttle body fuel injection fuel system equipped vehicles). A failure in one of the Passlock system’s components will cause the engine to start and then stall after a few seconds. This is due to the fact that the PCM, in your GM pickup or SUV, has disabled the fuel injectors.

How to check no spark and no fuel?

94 c1500 350 V8 This truck has started every time I started it since 94 except today, the fuel pump is not working I don’t hear it and no fuel is being pumped, and there is no spark to the plugs I check with my timing light, I check the fuse link at the block under the hood 12v ok there what do I check next thanks for the help in advance.

How to troubleshoot a GM 4.3L no start?

Check that the 8 cylinders are getting spark with a spark tester. The distributor cap is good. The ignition coil is good. The ignition control module is good. The crankshaft position sensor is good. The distributor cap could be bad. The ignition coil to distributor cap high tension wire could be bad. The ignition coil could be bad.

What should I do if my engine won’t start?

The very first thing you need to do is check for spark and the presence of fuel. Both of these tests should be done simultaneously if possible. As mentioned before, usually one of them will be missing from the mix. The idea behind checking for spark (with a spark tester) is to see if all of the 8 engine cylinders are getting spark.

Why does my 1988 Chevy Silverado not start?

I’ve got a 1988 K1500 with the 350 FI. It won’t start, turns over, but won’t start sounds like fuel problem. Fuel pump has been changed, fuel filter, Fuel pump relay, Fuel pump fuse, ignition coil, all have been changed or checked. Any ideas. It is getting power, just seems to not be getting any fuel. The possibilities are endless.

Why does my 1997 Chevy c1500 not start?

1997 Chevy C1500, 2WD, 5.7L won’t start – cranks fine. No codes – good fuel pressure ( 60+ psi – new pump), good spark, 1997 Chevy C1500, 2WD, 5.7L wont start – cranks fine. No… It will not start. I changed the fuel filter and fuel pump It will not start. I changed the fuel filter and fuel pump relay.

How to troubleshoot a no start GM 4.3L pick up?

Testing a Cranks but Does Not Start condition on your GM 4.3L, 5.0L, 5.7L pick up, van or SUV is not that hard to do, if you have a solid diagnostic strategy. In this article I’ll show you the basics of testing such a problem.

Why does my 1994 Chevy S-10 not start?

1994 Chevrolet S-10 4.3 tbi. I never get the signal to turn on the fuel pump or fire the injectors but if i poor gas in the intake once the truck starts it runs fine. Any ideas ? I have replaced the fuel pump relay oil pressure switch and computer.

Can a car start without priming with gas?

Engine wont start until you prime the throttle body with fuel, then it starts and runs great! Clicking this will make more experts see the question and we will remind you when it gets answered.

What do you need to know about engine will not start?

All engines require three things to start and run; spark, fuel and compression. So, if any one of these is missing, your engine will not start. With a engine will not start issue, the possible causes are plenty; so it’s important to understand, what it takes to make a engine start and run.

How to troubleshoot the fuel pump on a GM 4.3L?

Troubleshooting the fuel pump (GM 4.3L, 5.0L, 5.7L) (for ‘Spider’ fuel system equipped vehicles). How To Test The Fuel Pump On GM TBI Fuel Systems (for throttle body fuel injection fuel system equipped vehicles).

What happens if the fuel pump doesn’t work?

The fuel pump usually fails in one of two ways (in the pickups and SUVs covered in this article), it either fails completely and doesn’t send any fuel to the engine or it still runs, but doesn’t send enough fuel to start or keep the engine running.

Can a dirty fuel filter cause hard starting?

A dirty fuel filter may restrict the fuel system flow, or at least make it inconsistent, which can cause the vehicle to experience hard starting. This is more likely if the filter on the vehicle has never been changed.

Why does my fuel pump not start when I change it?

You always want to replace the fuel filter when replacing the fuel pump. This could cause the concern you are having. It may seem as you are getting enough fuel from the pressure regulator but if the pressure from the fuel tank is not correct, it will still not start. Another problem you could be having is spark.

Can a clogged fuel filter cause low engine pressure?

Some vehicles come equipped with fuel pressure sensors that monitor the pressure of the overall fuel system. A clogged fuel filter may cause low pressure, which will set off the Check Engine Light to alert the driver — if detected by the sensor.

https://www.youtube.com/watch?v=35hNd0pRjAs

What causes the fuel pump to not start?

The fuel pump is running and delivering normal pressure to the engine But, with all that working your engine still will not start. So, the most likely cause, is that the fuel injectors are probably not opening. The (PCM) uses the trigger signal from the crankshaft position sensor; and/or camshaft position sensor to pulse the injectors.

Why does my GM 4.3L engine not start?

No Start Condition Basics There are three very basic components that the engine, in your GM vehicle, needs to start and they are: Air, Fuel and Spark. When your 4.3L, 5.0L or 5.7L GM vehicle cranks but does not start, it’s because one of these components is missing from the mix.

How can I tell if my fuel pump is cranking?

Get under the truck and see if you can figure which wire powers the pump and check it with a volt meter or a test light to see if it is getting power key on and also cranking. while you are under there check the pump circuit ground because I recall them being down where they get bombarded with whatever might be on the road surface and corrode up.

What happens when fuel pump does not start?

The pump will trigger on the start circuit and run for about 15 seconds. If it does not sense oil pressure it will quit.

What causes a car to not start with no spark?

Without spark, the engine will Crank but Not Start. The ignition system of the GM vehicles covered by this article use a distributor type system. In my experience, the most common component failures, of the ignition system that cause a No Start No Spark Condition are: Distributor cap. Crank sensor.

How to test a no spark no start condition?

How To Test A Misfire / No Spark No Start Condition (at: easyautodiagnostics.com ). How To Test The Crank Sensor (GM 4.3L, 5.0L, 5.7L). How To Test The Camshaft Position Sensor Diagnostic Trouble Codes: P0340, P0341.

When does a GMC Truck shut off when in gear?

Chevrolet- GMC Truck Shuts Off When In Gear. After the motor heats up when i put the truck in drive. It also shut off when i put in reverse. The Chevy truck stalls . Sometimes the truck shuts off but mostly when i put the Chevrolet in drive it shuts off.sometimes it shuts off when i put the truck in gear. GMC Truck Shuts Off When In Gear.

Why does my GM Truck shut down while driving?

At a dead stop. It would crank over, but not start. Ran the battery dead trying to crank it. My dad came to help, charged the battery, and it started right up. It sounds wierd but this is what its doing.

What is the yellow light on a GM starter interrupt?

In this article, we are concentrating on factory-installed GM starter interrupt systems. This type of anti-theft system is designed to prevent the vehicle from starting unless the correct ignition key is used. These systems used a dash-mounted “security” or “theft” light which can be yellow or red in color.

What to do if your GMC Sierra stall out?

69 people found this helpful. I have a 98 gmc searria 4×4 i checked fuel pressure it was under i changed fuel pump and fuel filter and its still starving for fuel what to do it starts with starting fluid 42 people found this helpful.

Navigation