Why does my car starter keep running even with the key off?
If that wire is shorting to ground somewhere in the harness, that would explain why your starter was running even with the key off. If you have 12 volts at the little solenoid wire when it is disconnected, simply touch it to the negative battery terminal and the starter should run.
What to do if your car starter keeps cranking?
Appears the starter pinion does not retract once the engine starts. I had a similar problem a few weeks back on my car. Replaced the starter and all was well. You can whack it with a hammer, but it’s not a solution and dangerous to be under the car while the engine runs.
How can I tell if my car starter is running?
Next check for ground at the starter relay control. The relay should only get ground from the PCM when the ignition switch is in the START position. If you find ground in the RUN position, check the ignition switch wiring for your year, model/engine the START wire is NOT hot while the switch is in the RUN position.
What causes a motorcycle starter to keep running?
It’s common on motorcycles for the solenoid’s ground side to be the switched side which means the little wire going from the solenoid to the starter button (via the ignition switch) is always hot. If this wire shorts to ground, the starter will run without regard to ignition switch or starter button position.
Why does my Ford starter keep running even after I Turn Off the engine?
Some Ford owners encounter a situation where the starter run continuously or keeps running even after the engine has started and even after they’ve removed the key from the ignition. At first, this may make you think the starter drive is binding. Or you may think you have a bad starter relay.
What to do if your car starter stops?
To diagnose the problem, first try rotating the lock cylinder. If the starter motor stops, you’ve found the problem. Try lubricating the lock cylinder with a liquid graphite solution or spray dry Teflon lube.
Next check for ground at the starter relay control. The relay should only get ground from the PCM when the ignition switch is in the START position. If you find ground in the RUN position, check the ignition switch wiring for your year, model/engine the START wire is NOT hot while the switch is in the RUN position.
Why does my car engine not turn off when I remove the key?
Your engine will continue to run even when you remove the key from the ignition because the fuel pump is not shutting off. This problem is typically caused by a faulty fuel pump relay or a defective ignition switch. In this article, we take a look at why your engine won’t turn off when removing the key and what you can do to stop the engine.