Why does my air conditioner light keep flashing?
If your remote control does not have a test button, press temp-down, temp-up and the mode buttons simultaneously to get the error code. Another reason for air conditioner light flashing is when the circuit board has a problem. The procedure of fixing this is complex and should be handled only by an experienced technician.
Why is my ge window air conditioner blinking red?
GE window air conditioner filter light flashing / GE air conditioner blinking red light. GE Window-mounted air cons with a ‘Reset Filter’ pad (with LED) will turn on once the fan has run for 250 hours. This is simply to remind you to clean the filter. Clean the filter.
What to do if your GE window air conditioner is not working?
Simply disconnect power (or unplug it) to your GE air conditioner for two-three minutes then restore power. This usually resets the internal electronic parts and may help clear some of the common issues. You can also try to reset the electronics by turning off power completely at the main circuit breaker for about 30 seconds.
What causes an air conditioner to stop working?
6 Common Air Con Problems. There are a number of reasons as to why your air conditioner has stopped working, including one or more of the following: Unit is unplugged. Blocked filters and coils. Thermostat out of place. Blown circuit breakers and fuses. Ice buildup. Wrong settings.
What’s the problem with the temp gauge not working?
00 f150 4×4 4.2 xl I have repl. Cht sensor twice temp gauge stays below the c it idles high when first starts check engine light came back on this has just start a couple of days ago everything was working fine until then any ideas Answered! View the answer I have this problem too Is this a good question?
Why is my Ford coolant gauge not working?
A lot of Ford’s have 2 different coolant temp sensors. 1 for the pcm and 1 for the gauge. They are NOT interchangeable. One or both may be bad or they may be the wrong ones. Was this answer helpful? Similar prob: 94 toyota truck my gauge says cold. Idle high at stop lites. It was overheating and took therma out.
What should I do if my dash gauges are all out?
Dash gauges are all out and no power windows and no blower for air and heater and its as something shot or blew but the two places that I checked the fuses are not blown. What else might I do to see if the problem can be fixed without going into the shop? have the same problem? Will the vehicle start and run?
Is there a problem with my air conditioner?
The Air conditioner has been serviced. Compressor has no leaks and the Freon level is correct. All seems well except it’s blowing hot air instead of cold. I’m told it is a wiring problem?