Who can replace thermostats?
Thermostat Installation or Replacement Costs. Most electricians can install or replace a home, apartment, or business thermostat in two hours or less at a rate of $65 to $100 per hour for a total labor cost of less than $200.
How can I find a replacement thermostat for my home?
Purchase a replacement thermostat that will work with your system. Review the compatibilities listed on the packaging of the replacement thermostat. Most replacement thermostats are compatible with all common systems. However, if your system is unique, finding a replacement thermostat may be difficult.
How to know if your thermostat is compatible with your heating system?
To make sure a thermostat is compatible with your system, check that it can work with: Your system’s specific voltage The location on the wall The # of heating/cooling stages your system has Let’s go into more detail about each of these points… #1: Check your system’s voltage
When do I need to replace my HVAC thermostat?
If this clicking sound doesn’t occur, or if the system doesn’t come on shortly after the changes are made, the thermostat may need replacing. HVAC system short cycles: Short-cycling occurs when your HVAC system shuts off too early and fails to complete a full heating or cooling cycle.
What should I do if my thermostat is not working?
Check to make sure your replacement thermostat is working. Set the thermostat so the furnace and the air conditioner will come on at different times. Give your furnace and air conditioner at least 5 minutes each time to activate. If the thermostat does not work properly, retrace your steps to see where you made a mistake.
How do you replace a thermostat in a house?
Replacing a Thermostat in Your Home Purchase a replacement thermostat that will work with your system. Review the manufacturer instructions for wiring your replacement thermostat. Shut off the power to your thermostat. Remove the old thermostat from the wall. Pay attention to how the old thermostat was wired as you disconnect it.
How do you remove a thermostat?
Most thermostats can best be removed by gently being pulled from the wall. But be careful not to pull too hard as you might detach the base from the wall. If the cover doesn’t easily detach, you may need to remove a screw, or press a button or latch to remove it.
How do you wire a furnace thermostat?
Most thermostat systems have two wires. One is red, the other is white. Strip the casing ¼ inches from both ends of both wires. Install the white wire on the thermostat and the furnace terminals that say “W.”. Connect the red wire to the thermostat and the furnace at the terminals that are marked “R.”.