Where is the oil drain plug on a 2005 Harley Softail?
On Softail models, the oil reservoir is located under the seat. Look directly below the seat– and slightly behind it – underneath the frame to find the oil drain plug. Use a ratchet and 5/8-inch socket to remove the drain plug.
What oil does a 2005 Harley Softail take?
The Right Synthetic Motor Oil for Your 2005 Harley-Davidson FLSTN Softail Deluxe. AMSOIL synthetic lubricants are the solution for riders who want the most from their 2005 Harley-Davidson FLSTN Softail Deluxe. They resist the devastating effects of extreme heat, even in rally or parade traffic on hot days.
Where is the oil drain plug on a Harley Davidson?
The oil drain plug (or bolt, rather) is located under you bike in the center, in line with these rear foot pegs. Use a 5/8″ deep well socket to remove the oil drain plug. Make sure that you have your drain pan in place before you remove the plug. This part is where the bike should be level to get as much of the old oil out as possible. Figure 3.
Where is the oil filter on a Harley Davidson Softail?
Theoretically, the filter should be removable by hand only, but that is a rarity at best. The filter is located in front of the front V-Twin cylinder at the bottom. Turn the filter counterclockwise until it comes straight out.
How much oil should I put in my drain plug?
Torque the drain plug to 14 to 20 pounds, according to the manufacturer’s guidelines. The age-old question is what kind of oil you should use. Harley recommends their specific oil of course, but any motorcycle-rated oil will work just fine and you can choose between synthetic or regular Dino.
Where is the oil filter on a V-twin?
The filter is located in front of the front V-Twin cylinder at the bottom. Turn the filter counterclockwise until it comes straight out. Make sure that you have another drain pan in location before you pull the filter out to catch all the oil that is going to spill.
Where is the drain plug on a Softail?
On Softails, the drain plug is found between the rear shocks; Dyna and Touring models have drain plugs under the left side of the engine’s oil pan. Replace the drain plug’s O-ring, then screw it into place after the oil has drained. Tighten the drain plug to 18 foot-pounds with a torque wrench.
How to do an oil change on a Harley Davidson Softail?
Follow along as Bob teaches you how to drain the fluids on your Harley Softail, including the primary, engine oil and the transmission drain plugs. You’ll also learn how to expertly reinstall the oil filter, and which parts must be replaced each time you perform a Harley Davidson oil change and service your motorcycle.
Where is the drain plug on a Harley Davidson Dyna?
Dyna and Touring models have their oil drain plugs under the transmission housing. Drain the engine oil into an oil pan. Replace the drain plug’s O-ring, then screw it into place after the oil has drained. Tighten the drain plug to 18 foot-pounds with a torque wrench.
How do you change the oil in a Heritage Softail?
Unscrew the drain plug with a 5/8-inch socket and a socket wrench, or loosen the drain hose clamp with a flat-head screwdriver and pull out the hose plug. Allow your Heritage Softail’s oil to drain for a minimum of five minutes or until the flow of oil slows to a thin trickle.