Where is the oil drain on a road King?
Place a large drain pan below the Road King’s oil sump, positioned under the motor. Unscrew the oil tank and transmission filler caps from the right side of the Road King. Remove the motor oil drain plug from the side of the oil pan, facing the front of the motorcycle, using an Allen wrench.
Where is the oil plug on a Harley Road King?
Place your oil pan beneath the motor oil drain plug. The drain plug is located on the right side of the motor and to the rear of the frame. Remove the drain plug with a Torx socket and replace the plug’s o-ring.
Where are the drain plugs on a Harley Davidson?
There are two drain plugs. The plug towards the front left of the pan is the oil drain plug. The other one is for the transmission. Drain the oil, replace the filter, refill with three quarts of oil and you’re ready to go.
What kind of fluid does a Harley Davidson Road King use?
Regular fluid changes are a fundamental part of keeping your Harley-Davidson Road King roadworthy. Unlike the motors used by other manufacturers, Harley-Davidson employs three separate fluids to lubricate the Road King’s motor, primary drive and transmission systems.
Where is the oil drain plug on a road King?
The tank on your Road King is on the bottom of the transmission. Look underneath the transmission and you’ll see two drain plugs. The plug on left front of the oil pan is the engine oil drain. The plug near the center of the pan is the transmission drain plug. You can’t post conmments that contain an email address.
There are two drain plugs. The plug towards the front left of the pan is the oil drain plug. The other one is for the transmission. Drain the oil, replace the filter, refill with three quarts of oil and you’re ready to go.
How many oil drain plugs are in a pack?
Your engine configuration may vary from the photo above. 50 orange #11105 oil drain plug o-rings packaged in a plastic zip-top bag with Captain O-Ring LLC packaging. Would you like to tell us about a lower price?
When to replace oil drain plug # 11105?
Replace the #11105 o-rings each oil change to prevent leaks and keep your equipment running and in top shape. Molded from OEM spec material to match the performance you expect. Captain O-Ring’s orange o-rings are molded through with orange rubber material, not just a surface coating. Your engine configuration may vary from the photo above.
How to change the fluids in a 2003 Harley Davidson Road King?
How to Change the Fluids in a 2003 Harley Davidson Road King. 1 Step 1. Warm the motor up for 3 to 5 minutes, letting it idle in place or by taking the Road King for a short ride. Stop the motor once it has warmed 2 Step 2. 3 Step 3. 4 Step 4. 5 Step 5.
Is the primary drain plug tapered on a Harley Davidson?
Discussion in ‘ Engine, Fuel and Exhaust ‘ started by bikerod, Dec 6, 2013 . Advice needed have slight primary plug oil drip when oil hot,plug screwed in level with cover on 97 dynaglide. tried PTFE tape but doesn’t last.this plug is tapered and doesn’t use an o ring. Thanx guys. I know the lug on my 96 dyna screws in quite a way.
Place a large drain pan below the Road King’s oil sump, positioned under the motor. Unscrew the oil tank and transmission filler caps from the right side of the Road King. Remove the motor oil drain plug from the side of the oil pan, facing the front of the motorcycle, using an Allen wrench.