Where is the BCM located on a 2008 Pontiac g6?
The BCM is located on the drivers side under the the steering column. It is behind the fuses and to get to it you have to remove the bash board plastic, than a pice of metal and than you have to remove the fuses box. It will take you approximately 20 min to remove everything.
Does a 2008 Pontiac g6 have a chip in the key?
NOTE: This ignition key has a chip hidden inside of the plastic head. It is a part of your automobile security system to prevent theft. Therefore, you MUST get it both: cut and programmed. Cutting only will NOT allow you to start the engine.
How do you open the trunk on a G6?
With the key, with the electric trunk release, with a locksmith, and with a big hammer and screwdriver. Some year Fieros required the parking brake be applied to activate the electric release, some had to be in park, and some of the early models would work just by pushing the button.
Who is the owner of the 2008 Pontiac G6?
2008 Pontiac G6 Owner ManualM GENERAL MOTORS, GM, the GM Emblem, PONTIAC, the PONTIAC Emblem, and the name G6 are registered trademarks of General Motors Corporation. This manual includes the latest information at the time it was printed. We reserve the right to make changes after that time without further notice.
Where is the heat button on a Pontiac G6?
The buttons are located on the outboard side of the driver’s and front passenger’s seats. Press the top of the switch to turn the feature on. The seat will heat to the high setting. The indicator light above the switch will be lit next to the number 2. Press the top of the switch again to go to the low heat setting.
How does manual lumbar work on a Pontiac G6?
†Move the seat forward or rearward by sliding the control forward or rearward. †Raise or lower the front part of the seat cushion by moving the front of the control up or down. †Raise or lower the rear part of the seat cushion by moving the rear of the control up or down. Manual Lumbar