When does a Porsche 997 power window quit working?

When does a Porsche 997 power window quit working?

This article applies to the Porsche 997, 911 (2005-2012). Unfortunately, power windows don’t typically give much warning when they are about to quit working. They usually just die at the most inappropriate time—whether that be in the drive thru line or as you head into a thunderstorm.

What happens when you open the passenger side window?

When I put the car back in service the passenger side door window no longer auto-adjusts when you open and close. Previously, when opening the door with a fully closed window, the window would jog down about 1/4″ – 1/2″ when you lift the door handle and jog back to a fully closed position when the door shuts. The driver side door works fine.

How to remove rear window regulator 996 cab-996 series?

Push rear power window -11- upward and push both locking tabs of the electrical connection -13- outward and disconnect. 1.Inserting power window. Connect electrical plug connection -13-, insert power window -11- into the window shaft from above and position in the mounts in the inner side section. 2. Screwing down convertible-top support.

How do you remove a Porsche Carrera door panel?

To remove or replace the window switches you will need to remove the door panel. (see Pelican Technical Article: Porsche 911 Carrera Door Panel Removal). Once the panel is off, you can remove the window switch by first disconnecting the wiring. Squeeze the tap (red arrow) and pull straight back.

How to change the window regulator on a Porsche 911 Carrera?

Squeeze the tap (red arrow) and pull straight back. The switch is held in place by a locking tab (green arrow) gently pry it down and slip the switch out. The 997 doors are a modular design that incorporate an inner aluminum panel within the door frame.

Where is the rear bumper on a Porsche?

Quarter panel for the right side of Targa (1974-1989) models. Rear bumper for 911 and Turbo models 1974 thru 1977. Rear bumper for 911 models. Rear bumper for 911 and Turbo models 1978 thru 1989.

Where is the rear quarter panel on a Porsche 911?

Left lower rear quarter panel for 930 (1976-1989) at the bottom of the rear fender below the bumper. Right lower rear quarter panel for 930 (1976-1989) at the bottom of the rear fender below the bumper. Outer rocker panel for 911 (1974-1989), 912E (1976), C2/C4 (1989-1994) models.