When did I install LED lights on my trailer?
LED lights had been installed on this trailer about a year ago. If any paint work or welding is required, I would recommend doing that first before installing the new wiring. To make this tutorial easier to understand, I will be flipping the trailer on it’s side so everything is easily viewable.
How to renew or upgrade your NSW driver licence?
How to renew or upgrade online Check the eligibility requirements. Select the ‘Renew or upgrade licence’ button. Log in, or create your MyServiceNSW Account. Enter your NSW driver licence details if your account is new or you haven’t… Follow the prompts to renew or upgrade your driver licence. …
Is it possible to get a new drivers license online?
If you renew online, your new licence card will be printed using the photo already stored by TfNSW. Carry your old licence card with you when you drive, if you still have it. If your temporary paper licence is lost, stolen or damaged before you receive your new licence card, you can get a copy of it online.
What’s the best way to wire a trailer light?
Use a center drill as a pilot hole and then select the correct size for the split casing. Make sure to de-burr these holes so you don’t risk damaging the casing when pulling it through. Just use a larger sized drill bit or step drill and turn it by hand.
How to wire a light in a license plate?
How to Wire a Light in a License Plate 1 Purchase a license plate light fixture as well as a light bulb. 2 Drill a mounting hole on the underside of the mounting area. 3 The E Trailer website explains that most lighting systems are powered by a direct-current system with two wired ends.
Do you have to light your license plate at night?
All vehicles in the United States are required to illuminate the license plate at night, according to the National Highway Traffic Safety Administration. If the headlights and taillights are turned on, the rear license plate also should be lit. Most vehicles are equipped with license plate lights…
What are the common mistakes people make when wiring LED lighting?
A common mistake people make when wiring LED lighting products is trying to simplify the installation by jamming 10 wires into a wire nut or phoenix connector.
Do you need serial connection for LED lights?
For first time LED installers serial connections seem like common sense when wiring your LED lights. What people don’t realize is that each little LED and it’s components takes a bit of voltage away from the next in a series.