What size of socket is needed to remove the axle nut?
36mm
A Must Have for Front End Work This 36mm axle nut socket is extra deep to fit various axle lengths and can be used to remove or install axle nuts on front wheel drive vehicles.
What size is the spindle nut?
The Nut is a 1 inch nut with 14 threads. The socket or wrench needed for this is 1-1/2 inch.
What is a GM 10 bolt front axle?
The GM 10 Bolt front axle was used on Chevy and GMC 1/2 ton and 3/4 ton 4×4 pickups from 1977 to 1987 and on Blazer/Jimmy, and Suburban SUVs from 1977 through 1991. Identify a GM 10 Bolt Front Axle: Type: Iron beam 4×4 Front Drive Axle Front…
How much does it cost to replace a car spindle?
A faulty spindle can cause steering and driving problems with your car that may lead to a serious catastrophe. The prices for aftermarket spindles on our website range from $36 for a single piece to $420 for a set two.
How tight should spindle nuts be?
The nut on the spindle should be tightened until snug, with no side-to-side play in the hub and then backed off, about a quarter of a turn. The nut finger should be tight until the castle nut or cotter pin is used.
Is a Dana 44 a 1 ton axle?
Yes, D60s are widely considered “one ton axles” but the fact of the matter is, they made many 3/4 ton trucks with D60 front axles and many 1 ton trucks with D44 front axles.
How do I identify my GM front differential?
Information about Differentials in GM vehicles can usually be obtained by looking at the RPO or “Regular Production Option” codes contained in the Service Parts Identification tag in the glovebox. Whenever possible, reference the tag numbers when ordering parts for your Differential.
How big is the drop on a C10 suspension?
This design also reduces under and oversteer and dramatically improves cornering and performance. Front coils include choice of one 4-inch drop while rear coils include choice of two 6-inch drop.
Is the Dakota pickup truck still being made?
Unfortunately, the Dakota doesn’t live up to the same standards. This truck may be tempting to buy used. It’s no longer being made, and that can make used prices tempting. If you can’t resist and you do purchase one, you may have to deal with inconsistent oil pressure and sludge build up.
What kind of suspension do I need for my truck?
This kit includes: front and rear coils, front and rear sway bars, adjustable Trac bar with polyurethane bushings, front and rear shocks, all sway bar mounting hardware as well as installation instructions. NOTE: When lowering your truck 3-4 inches in the front, we highly recommend using Performance Online’s front shock relocator kit.
Where do you put the spindles on a C10 wide ride?
Place the spindles over the bottom ball joint first, followed by the top then attach the outer tie rod end and tighten and three up. Don’t forget to run cotter pins through the castle nuts and through the ball joint studs. With that said, this is how things should look.