What should you do if you wait too long at a red light?
If the “don’t walk” signal has been there a little while, drive about a half-mile per hour over the speed limit to the next light, then continue at exactly the speed limit. You do not need to speed; in fact, going over the speed limit will make you wait at a red light.
How to reset a motion light that stays on all the time?
Check the time switch to confirm it isn’t set in “Test” mode. If set in “Test” mode, move the switch to a pre-determined time setting. The “Test” mode could cause the light to come on and remain on. Reset the light to make sure it isn’t set to manual operation. Turn off the light switch that operates the motion light.
What should you do when a traffic light turns green?
There’s one very simple answer to this: when the light turns green, and you begin driving, accelerate slowly and smoothly up to the speed limit. Then drive the speed limit. Why does this work? Traffic signals tend to be timed in sequence, so that if you make one green light, you will make them all.
What should I do if my PassLock security light goes off?
If nothing happens or the engine starts and dies, the security light will be flashing. Wait ten minutes. The flashing light should go off or illuminate without flashing. When it does, turn the ignition off, wait twenty seconds, and then try to start the engine. If it starts and runs, everything is okay.
How long does it take for security lights to go off?
If not, try turning the lights off at the breaker for around 20 seconds. Confirm visually that the security lights have gone off and then turn the breaker back on. The light will reappear but should go off after a few minutes.
Why does my security light keep coming on?
It happens to the best of us. If the light is on when the switch is set to manual but doesn’t catch movement, check the detector sensitivity setting. This may need adjusting if you’ve added lighting or large structures to the area.
What should I do if I replace my security light?
If you’re replacing an old fixture, make sure to also replace the neoprene gasket to keep water from making its way into the opening. Attach per the directions for your security light and then check the programs. Adjust the brightness and motion sensitivity to your area.