What should my TPS be on my car?
The TPS should read between 4.0 and 5.5 volts. If the TPS reads outside of this range, the sensor must be adjusted. Loosen the throttle position sensor retaining screw with a Phillips-head screwdriver. Adjust the TPS by moving it back and forth until the voltage is between 4.0 and 5.5 volts.
When to remove the TPS on a throttle?
When doing this, it is important that the TPS should be removed to prevent contamination (a primary cause for failure) and the throttle body-to-plenum gasket replaced. We strongly recommend cleaning your throttle body thoroughly before attempting any adjustment.
What is the peak reading voltage of a Yamaha DVA?
DVA (Peak Reading) Voltage and Resistance Chart HP YEAR # Cyl STK Model Stator Trigger CDI Out Ignition Coil SPK PLG CAP Read Ohms DVA Read Ohms DVA OHMS +/- 10% Low Spd High Spd Low Spd High Spd Low Spd High Spd Primary Sec
How do you adjust the TPS on a Honda Accord?
How to Adjust the TPS on a Honda. Turn the engine on and let it warm up for about five minutes. Shut the engine off and locate the AWS hose in the back of the carburetor attached to the curved inlet pipe near the throttle arm. Remove the AWS hose from the inlet pipe to access the TPS sensor on the firewall.
What should the voltage be on a TPS cable?
Put the red lead to the Yellow wire on the TPS connector and make sure you have 5.00-5.01 volts. If thats good, now move your back probe to the blue wire on the TPS connector. You should have something in the .690-.712 volt range, thats the spec for your BASE setting.
How to test a throttle position sensor ( TPS )?
Alternator Testing & Repair (EVERYTHING You Need To Know!) An error occurred while retrieving sharing information. Please try again later. Ultimate Guide To Engine Starters! (The ONLY Video You’ll Need) How To Replace A Broken Power Window & Door Lock Switch! (Step By Step)
Where do I hook up the TPS meter?
Next step is to provide 12volts to the ECU connector in front of the clutch cover near the upper shock mount. Apply B+ to the orange wire and ground to the black/blue wire. Now hook up a GOOD quality volt meter to the TPS connector, its in the bag right above the PTO spark plug.
How do you adjust TPS on a sled?
Then slide the shroud back from the steering post, pull the starter rope out a foot or 2 and then just lay that off to the side of the sled. Next remove the seat buy taking off the 4 10mm nuts on the seat mount, lifting it up off the studs and then slide straight back.