What RPM should you polish at?
Lower RPMs means less friction, less friction means less heat buildup. Try to stay between 1750-2400 RPM when compounding and between 1200-1750 RPM when finishing. After using compound wash the treated area with soap and water to eliminate excess compound grit. When finishing with a polish or glaze, don’t buff dry.
Can you polish with rotary buffer?
A circular / rotary polisher can remove almost any scratches or swirls and most oxidation, as long as they do not penetrate beneath the clear coat.
What is the best temperature to polish a car?
The best conditions for using compounds, polishes, waxes and paint sealants on automotive paints would be in a cool place, out of direct sunlight, in a surface temperature range between 60 degrees and 80 degrees Fahrenheit, with comfortable to low humidity and with a light breeze to create the perfect conditions for …
What RPM do I put wax on?
Typically, you’ll work between 1000-1200 RPM, never exceeding 1800 RPM. Keep the polisher moving at all times to avoid burning the paint. Avoid corners and the edges of panels where the paint is thinner.
What causes swirls when buffing?
Even microscopic dust and dirt on a buffing pad will cause microscratches, so if you use a pad that was dropped on the floor, or was used on another vehicle without being cleaned, that pad is more abrasive and will cause swirls.
Is Rotary better than dual action?
Rotary polishers cut away paint faster than dual action (DA) polishers. This means DA polishers are easier and safer to use for beginners. Dual-action polishers rotate in two circular directions, whereas rotary polishers only spin in one direction, causing a faster build-up of heat and friction.
What should the speed of a rotary polisher be?
The clear coat is usually between 1.5 and 2 mils thick. Work at a slow speed and increase gradually if needed. Typically, you’ll work between 1000-1200 RPM, never exceeding 1800 RPM. Keep the polisher moving at all times to avoid burning the paint.
What’s the best way to use a circular polisher?
Polishing Tips First and foremost, keep the polisher moving at all times. Never let a circular polisher rest on the paint. Work at a slow speed, between 1000-1200 RPM. A circular polisher is capable of getting very hot, especially at high speeds.
Which is hotter a dual action or circular polisher?
The heat is on! Circular / Rotary polishers get much hotter than dual action polishers because the pad is spinning at a high speed. You MUST keep a circular / rotary polisher moving at all times so this heat doesn’t concentrate on one spot. It will burn through the paint in seconds.
Which is better random orbit or rotary polisher?
The random orbit polisher normally spins almost as fast as a rotary but also follows your hand motion. Though this is not exactly similar to rotary polisher when it comes to speed. If you are a secondary learner & used standard orbit polisher before then, you can give this a try for better results & performance.