What parts do you need to replace a starter?
Tools needed to replace a starter:
- Sockets and wrenches.
- Screwdriver.
- Pliers.
- Battery terminal puller.
- Drive-on ramps, jack or jackstands.
What is the part that needs to be disconnected first when replacing the starter motor and why?
Always disconnect the battery before removing the starter motor, which is often awkwardly placed low down on the engine . You may have to raise the car on axle stands and work from below. Disconnect the battery (earth terminal first) to avoid an accidental short circuit.
What should you follow when removing and refitting any starter motor assembly components?
Turn off the ignition and remove the negative battery cable from the battery. Remove the positive cable (the large cable that runs to the battery) from the starter. Disconnect all the bolts that hold the starter to the block, using a ratchet. Remove any other supporting brackets holding the starter in place.
What are the parts on a starter?
All Parts Of Starter Motor and function
- Solenoid starter. The first component you can see on the part that looks like a small tubular part on the main motor.
- Solenoid plunger. The plunger is located at the end of the pull in coil.
- Solenoid cap.
- Field Coil.
- Armature coil.
- Commutators.
- Drive lever / Actuator shaft.
- Brushes.
How to remove a car starter from the engine?
Remove the starter retaining bolts then the starter. 1 Be sure to use the correct size socket, otherwise you risk damaging the bolts. 2 You may need to pull on the starter with a bit of force in order to remove it from the engine once the bolts have been… More
Where do you disconnect battery from starter motor?
Locate the battery cable and any other wires attached to the rear of your starter motor — or solenoid on top of the starter — and disconnect them using a wrench. Make a note of the location of each wire so that you can replace them correctly, if necessary.
Do you need to remove negative cable to replace car starter?
You only need to remove the negative cable. This is a good move any time you’re working on the car. NOTE: Many vehicles need to be raised up to reach the starter. On others, obtaining starter access can be difficult. Check your vehicle repair manual for location and replacement details.
Why do I need to replace my starter motor?
Starter motor failure is rarely caused by a blown or shorted motor itself—usually it’s a problem with the bendix mechanism or the solenoid. And frankly, most people will never need to replace a starter motor for the life of their vehicle.