What kind of power does a Dyna FXDC have?
Discussion in ‘ Electrical ‘ started by cyborg, Sep 22, 2010 . 09 Dyna FXDC, got power everywhere. Lights,Horn,Turn`s,Fuel Pump,Dash, Turn the key on, hit the run/stop switch, push the start button and Nothing. Not even a click or a buzz.
Why does my Dyna FXDC bike not start?
Alarm, clutch inhibit & neutral safety all come from the TSSM. The TSSM controls the start relay. 09 Dyna FXDC, got power everywhere. Lights,Horn,Turn`s,Fuel Pump,Dash, Turn the key on, hit the run/stop switch, push the start button and Nothing. Not even a click or a buzz. Bike has been sitting for about 2 weeks.
What do I need to turn on switched accessory power?
Place a piece of cardboard between the wire and the harness before gently shaving away about two-thirds of an inch of insulation. A sharp knife and a slow pace are all you need. You didn’t forget to disconnect the negative pole of the battery before you began slicing, did you?
What’s the handlebar switch on a Harley Davidson?
The demonstration Bob and Mark give us is only on the Softail right side handlebar switch, but it is a good window on how almost everything functions on a 12 volt system. When an ECM is involved, there may be some low voltage functions but testing these functions, or circuits will be virtually the same.
What to do if your Dyna Glide won’t start?
Typical Dyna Glide fuse box layout. It usually a good idea to open up the right handlebar switch assembly and check for corrosion on the starter and run switches. While it is not a very common problem, checking for a faulty starter switch is one last area to inspect before setting your sights on the starter assembly itself. Figure 6.
What should the voltage be on a Harley Davidson Dyna Glide?
Use a voltmeter to measure the available voltage at the battery. A battery that is 100% charged will have approximately 12.6 volts, whereas a battery with a 0% charge will read 11.8 volts or lower. If your battery is low, charge the battery on a setting no higher than five amps for a few hours.
Where is the starter relay on a Dyna Glide?
Starter solenoid electrical connections. Another component to inspect is the starter relay, which is located in the electrical fuse box underneath the side cover on the left side of the motorcycle. Relays have the potential to go bad and prevent high current from reaching the starter.
Discussion in ‘ Electrical ‘ started by cyborg, Sep 22, 2010 . 09 Dyna FXDC, got power everywhere. Lights,Horn,Turn`s,Fuel Pump,Dash, Turn the key on, hit the run/stop switch, push the start button and Nothing. Not even a click or a buzz.