What is the torque for camshaft bolts?
Small Block Chevy Torque Specs
| Fastener Type | Torque Spec |
|---|---|
| Cam Sprocket Bolts | 18-20 ft.-lbs. |
| Harmonic Damper Bolt | 60 ft.-lbs. |
| Flywheel/Flexplate Bolts | 65 ft.-lbs. |
| Pressure Plate Bolts | 35 ft.-lbs. |
What holds a camshaft in place?
What holds the camshaft in the correct position and stops it from coming out during normal engine operation? Cam shaft retainer or thrust plate are common names. It’s a piece that’s bolted onto the engine block before putting the timing gear on.
What’s the final torque on a cam plate?
Tighten cam plate screws in sequence according to manual, do not final torque. Turn engine until the flat surface on the crankshaft is horizontal. Carefully torque cam plate bolts in steps as listed in service manual. Final torque on these bolts is 120 in-lb
How much torque does a SR20 camshaft have?
Evenly tighten 1/2 turn on each bolt until all of the caps are snug (1.4 ft -lb and again to 4.3 ft -lb). Then final torque the bolts from the center bolts out ward to 6.7 to 8.7 ft -lb for all of the bolts with a 10 M.M. head. The 2 larger bolts (12M.M. head) closest the distributor are torqued to 13 to 19 ft-lb. 10.
How to install a new camshaft on a camshaft?
CAMSHAFT INSTALL KA24DE INSTRUCTIONS 1. It is highly recommended that an oil and filter change be done before installing new cams. 2. Remove the plug wires, and valve cover from the en- gine. Use caution not to drop anything into the engine. 3.
How do you attach a sprocket to a cam?
Attach the sprockets to the new cams and screw the bolts in by hand. If you have positioned the cams dowels correctly, only a slight rotation of the cams will be needed to engage the dowel and sprocket. Check to see that the spro cket is fully seated against the cam before torquing the bolt tight.