What is the procedure for using compressed air to remove a piston from a brake caliper?
Place the rubber tipped blow gun in the main hole where the brake line attaches. Hold the air gun firmly in place to provide a tight seal. Slowly apply pressure; the piston should slide out under the air pressure.
Is it OK to reset your brake caliper pistons?
Note: Never use sharp or metal objects to reset the position of the pistons as you may cause damage. Now you’ve reset the position of the caliper pistons you can go ahead and insert your new brake pads or bleed block. Shares tips and advice on the dark-art of brake-bleeding.
What’s the best way to reset brake pads?
The easiest way is with the brake pads in situ. Simply push a flat blade screwdriver in between the brake pads and twist. This will separate the brake pads and, in turn, push back the pistons to the reset position.
Is the rear caliper controlled by the brakes?
The rear caliper piston is also controlled by the electronic brakes, and it just wouldn’t budge. The traditional caliper tool doesn’t work… If you have done this before, what tool did you use?
How to replace rear brake pads with est201?
When you first go into service mode it stores an error code which gets cleared at this stage if everything is in order. Assuming there are no error messages all you have to do is put the wheels back on and jack it back down again and remove the EST201 from the port and the job is done. Hope this helps someone.
Why are my caliper pistons not resetting properly?
If you’re having difficulty resetting the position of your caliper pistons it is probably because your brake has been filled with too much brake fluid. The brake system can become over-filled if a brake bleed is performed without resetting the pistons.
How to retract the rear caliper piston with an integral parking brake?
How to retract the rear caliper piston with an integral parking brake. This style requires you to twist and push the piston in at the same time. They cannot be simply pushed back in. Category Autos & Vehicles Show moreShow less Loading… Advertisement AutoplayWhen autoplay is enabled, a suggested video will automatically play next.
When you first go into service mode it stores an error code which gets cleared at this stage if everything is in order. Assuming there are no error messages all you have to do is put the wheels back on and jack it back down again and remove the EST201 from the port and the job is done. Hope this helps someone.
Is it OK to compress rear brake caliper?
Brake Caliper Piston Compressor Windback. This is what should be used: http://amzn.to/2ECIIWW It is not recommended that you compress a wind back caliper in this fashion and you run the risk of damaging the rubber boot or damaging the brake caliper piston. I only recommend using this method if you are in a jam.