What is a tip sensor on a motorcycle?
Tip over sensor cuts ECM controls of injectors, coils and fuel pump. It should not do this until bike is leaned more than… uh… some amount of degrees towards the mother earth.
What is a motorcycle bank angle sensor?
A bank angle sensor is a safety device that detects if a motorbike is leaning on an extreme angle or if the bike has been dropped, and subsequently cuts power to the engine.
What do you do with O2 sensors on a Harley Davidson?
If you do not utilize your stock O2 sensors, you will need to use O2 eliminators. They snap onto your your harness where the O2 sensors were, previously, plugged in. Depending on what type of tuner you have; you may need to communicate to a tuner that the sensors are absent.
When does bank angle sensor shut off Harley Davidson?
Discussion in ‘ General Harley Davidson Topic ‘ started by Ishmael, Feb 22, 2011 . A quick question for those of you more in the know than I. Yesterday when I went down, the bank angle sensor shut the engine off. I had read my service manual and knew that all I had to do was turn the switch off, back on and the engine fired.
What should the lean angle be on a Harley Davidson?
The factory quoted max lean angle (spec sheet) for my bike is 33* & 31*. I wish there was a simple way to turn that part of the software off. For me mentally, it should be a greater angle (say 75*).
How to install a sidecar tip sensor kit?
Remove the right-side cover. If the battery tray (1) does not have the inscription “Sidecar Tip Sensor” as shown in Figure 1 you must purchase and install the Battery Tray Kit (66281-09A) before installing the sidecar. Remove the left-side saddlebag according to the instructions in the Service Manual.
Where are the sensors on a Harley Davidson?
The actuator includes a geared permanent magnet DC motor and two sealed automotive style throttle position sensors which are located on the induction module body. Harley’s throttle by wire assembly can have issues. If there is an error, the system will go into one of three different failure modes.
Where is the twist grip sensor on a Harley Davidson?
It allows the twist grip sensor to communicate with the throttle control actuator. The actuator includes a geared permanent magnet DC motor and two sealed automotive style throttle position sensors which are located on the induction module body. Harley’s throttle by wire assembly can have issues.
Is there a crank crankshaft position sensor for a Harley?
[Fitment] – Crank crankshaft position sensor fits for 2004-2016 Harley Touring FLH/T, Fits for 2006-2018 Harley Sportster XL, Fits for 2001-2017 Softail FXST/FLST, Fits for 2006-2017 Dyna FXD. [Replace Part Number] – 32707-01C, TR484897, 933-1001
Discussion in ‘ General Harley Davidson Topic ‘ started by Ishmael, Feb 22, 2011 . A quick question for those of you more in the know than I. Yesterday when I went down, the bank angle sensor shut the engine off. I had read my service manual and knew that all I had to do was turn the switch off, back on and the engine fired.