What does unote mean in the Vulcan installation manual?
This manual is a reference guide for installing the Vulcan Series units. Important text that requires special attention from the reader is emphasized as follows: ÚNote: Used to draw the reader’s attention to a comment or some important information.
Where can I find the Vulcan parts Manual?
948RX AGM48 MSA48 For additional information on Vulcan or to locate an authorized parts and service provider in your area, visit our website at www.vulcanequipment.com – 2- IMPORTANT FOR YOUR SAFETY
How big is the back of a Vulcan?
INSTALLATION CLEARANCES COMBUSTIBLE CONSTRUCTION NON-COMBUSTIBLE CONSTRUCTION Back: 6” 0” Right Side: 6” 0” Left Side 6” 0” INSTALLATION CODES AND STANDARDS
Which is the installation manual for Vulcan Gas griddles?
RETAIN THIS MANUAL FOR FUTURE USE FORM F-38315 (rev. 07-16) INSTALLATION & OPERATION MANUAL HEAVY DUTY GAS GRIDDLES MODELS 924RX 936RX 948RX 960RX 972RX MSA24 ASA24 MSA36 ASA36 MSA48 ASA48 MSA60 ASA60 MSA72 ASA72 AGM24 AGM36 AGM48 AGM60 AGM72 948RX AGM48 MSA48
How to install a Vulcan front lift crank handle?
Front, Rear & Side Panels 1. Lift up on the bottom edge of panel until it clears the catch. 2. Tilt outwards and allow the panel to drop down. 3. Reverse procedure to install. Fig. 2 Control Panel 1. Remove front panel. 2. Disconnect conduit from control box. Fig. 3 3. Remove manual lift crank handle (if installed).
What is the installation and operation manual for Vulcan?
MODELS 924RX 936RX 948RX 960RX 972RX MSA24 ASA24 MSA36 ASA36 MSA48 ASA48 MSA60 ASA60 MSA72 ASA72 AGM24 AGM36 AGM48 AGM60 AGM72 948RX AGM48 MSA48 For additional information on Vulcan or to locate an authorized parts and service provider in your area, visit our website at www.vulcanequipment.com – 2-
What kind of Vom do I need for Vulcan?
NOTE: Any quality VOM with a sensitivity of 20,000 ohms per volt can be used. • U-Tube Manometer. • Temperature tester (thermocouple type) with surface probe. Special • 1 5/8″ open end wrench. Used for removing lid springs and adjusting lid spring tension.
How do you replace a Vulcan front panel?
REMOVAL AND REPLACEMENT OF PARTS COVERS AND PANELS Front, Rear & Side Panels 1. Lift up on the bottom edge of panel until it clears the catch. 2. Tilt outwards and allow the panel to drop down. 3. Reverse procedure to install. Fig. 2 Control Panel 1. Remove front panel.