What does the Mil light on a Saab 9000 mean?
This procedure is also available at wap.saab9000.com for access by wap-enabled mobile phone. The Saab 9000 engine management system monitors the engine for faults and will illuminate the “Check engine” warning light (“Malfunction Indicator Lamp” or “MIL”) on the instrument panel if a fault is found.
What to do when you get your Saab flash fault code?
Turn your jumper switch back to the “off position” 6.This is when you get your flash code the first flash of the check Engine light should be a long one the next will be short flashes with a pause in between numbers.
Why does my Saab check engine light keep coming on?
When your Saab check engine light stays on, it means that the On-Board Diagnostic (OBD) computer has detected a malfunction. The cause could be an engine problem, a fuel system leak, or even an indication of a transmission issue. Since a fault code will be stored in your Saab’s OBD computer, you can use an OBD-II scanner to read those codes.
What causes MAF sensor to go bad in Saab?
MAF sensor may function fine when the engine is cold then start to malfunction once the engine warms up. A coolant temperature sensor can go bad with time, causing the engine to run rich and preventing it from going into the ‘closed-loop’ mode.
This procedure is also available at wap.saab9000.com for access by wap-enabled mobile phone. The Saab 9000 engine management system monitors the engine for faults and will illuminate the “Check engine” warning light (“Malfunction Indicator Lamp” or “MIL”) on the instrument panel if a fault is found.
What does the Check Engine light mean in a Saab?
The check engine light is part of the onboard diagnostics (OBD) system in your Saab. What Does The Check Engine Light Mean When Illuminated? When you see the check engine light illuminated in your dash, it means your Saab has detected a problem within its OBD system. What Problems Can Trigger the Check Engine Light?
Where is the fault code stored on a Saab?
Since a fault code will be stored in your Saab’s OBD computer, you can use an OBD-II scanner to read those codes. When your Saab check engine light comes on, you may notice:
What should I expect when I visit my Saab mechanic?
If you also notice on your dash, in addition to the activated check engine light, that you have low oil pressure or your Saab is overheating, you should safely pull off the road as soon as you can and shut off the engine. What Should I Expect When I Visit my Saab Mechanic for Diagnosis?
What kind of engine does a Saab 9000 CD have?
The CD version of Saab 9000 is the 4-door sedan edition of this popular model introduced by the Swedish manufacturer in 1985. If the first cars came with a single turbo engine, the 1994 model had multiple engine configurations, ranging between 2.0 turbo and 3.0i V6, producing from 130 up to 210 horsepower.
What does check engine light on 1996 Saab mean?
A check engine light can indicate a broad spectrum of problems with your 1996 Saab 900. In some cases you need to pull over immediately to prevent damage while in others you merely need to tighten you gas cap next time you stop in order to reset the service engine soon light.
When to replace the front turn signal on a Saab 900?
Replace the front turn signal If your blinker doesn’t blink, or blinks rapidly, you likely have a burnt out bulb 1996 Saab 900 SE Turbo 2.0L 4 Cyl. Turbo Convertible (2 Door) Replace a burnt out DRL DRLs are on more than your headlights. They burn out faster and should be replaced regularly 1996 Saab 900 SE Turbo 2.0L 4 Cyl.
A check engine light can indicate a broad spectrum of problems with your 1996 Saab 900. In some cases you need to pull over immediately to prevent damage while in others you merely need to tighten you gas cap next time you stop in order to reset the service engine soon light.
What is the owner’s manual for a 1994 Saab 9000?
Owner’s Manual Saab 9000 M 1994 Instruments and controls 5 Interior equipment 27 Doors, locks and lu gage compartment 41 tarting and driving 49 Car care and maintenance 65 Technical data 93 Index 104 Saab Automobile AB 1993 Service Support, Saab Automobile AB Trollhättan, Sweden Printed by: Graphic Systems AB, Gåteborg
Where is the Check Engine light on a Saab?
Now we can get down to pulling codes. 1. ground pin 3 on the 3 pin test socket in engine compartment or pin 2 on test connector under back seat depending on your model. 2.Turn on the ignition to the run position( the check engine light should be on )
What kind of engine does a Saab 9000 have?
The Saab 9000 range consists of two models: • 9000 CS – 5-door Combi-Sedan model with 2.0-litre and 2.3-litre fuel injection engine or 2.0-litre and 2.3-litre turbo- charged engine. • 9000 CD – 4-door Sedan model with 2.0- litre and 2.3-litre fuel injection engine or 2.0-litre and 2.3-litre turbocharged en- gine.
When your Saab check engine light stays on, it means that the On-Board Diagnostic (OBD) computer has detected a malfunction. The cause could be an engine problem, a fuel system leak, or even an indication of a transmission issue. Since a fault code will be stored in your Saab’s OBD computer, you can use an OBD-II scanner to read those codes.
MAF sensor may function fine when the engine is cold then start to malfunction once the engine warms up. A coolant temperature sensor can go bad with time, causing the engine to run rich and preventing it from going into the ‘closed-loop’ mode.