What does the Diagnostic Code p0882 mean?
Code P0882 indicates there isn’t enough power getting to the transmission module. This is usually due to a problem with the power input circuit. The ‘low’ portion of the diagnostic trouble code (DTC) indicates a short circuit, whereas ‘high’ would indicate and open circuit.
What causes a low p0882 power input signal?
Low voltage from the battery, or an open or shorted circuit in the transmission control circuit are common causes of a P0882 code. What are the symptoms of a P0882 code?
When to change the p0882 Transmission Control Module?
Sometimes this code is triggered when the battery charge gets too low or is replaced. Cleared the code and drive the vehicle. If the code comes back and there are no other symptoms, you may have to replace the Transmission Control Module (TCM). The cost of diagnosing the P0882 code is 1.0 hour of labor.
Where are p0882 TCM related codes stored?
TCM related codes are stored as P-codes, B-codes, or even U-codes, depending on vehicle make and model. If a P0882 code is stored, there is a good chance that there are other PCM and/or TCM codes stored as well.
Code P0882 indicates there isn’t enough power getting to the transmission module. This is usually due to a problem with the power input circuit. The ‘low’ portion of the diagnostic trouble code (DTC) indicates a short circuit, whereas ‘high’ would indicate and open circuit.
Low voltage from the battery, or an open or shorted circuit in the transmission control circuit are common causes of a P0882 code. What are the symptoms of a P0882 code?
When to know if DTC p0882 is a problem?
A telltale sign that the battery is weak and may be causing DTC P0882 is if you require a boost to start the engine. Alternatively, perform a load test on the battery. Many auto parts retailers will perform out-of-vehicle load testing on batteries for no charge.
How to clear p0882 TCM power input signal?
Any ideas, suggestions All fuses are ok,swap relays no luck Vehicle wont come out of parking at times Check engine light on with this 3 codes Clear them and they come back right away After cycling the ignition switch from run to off back to run….