What do you need to remove steering wheel on VW?
All right, the tools we’re going to need for this job is going to be a Phillips head screwdriver, a ratchet, an extension, a 24 millimeter socket, the keys to the vehicle, and a pocket screwdriver, or the Volkswagen special tool for removing airbags. Now, you’re going to want to remove the steering column trim.
What kind of steering pivot pin remover do I Need?
Would you like to tell us about a lower price ? OTC’s No. 7889 Steering Pivot Pin Remover for 1969 and up GM, Chrysler, and Ford vehicles with Saginaw steering columns, greatly simplifies tilt steering column service procedures. Tool includes cup adapter, forcing screw, nut, and washer.
Can a screwdriver be used to pry up a steering wheel?
DO NOT pry up with the screwdriver but instead push the nose of the screwdriver down otherwise you will rip the cover of the steering wheel. Also, sometimes squeezing the airbag into the steering wheel will help relieve a little bit of tension
How do you remove the steering column trim?
Pull Tip: Releasing the airbag can be tricky, so remember to be patient. First, remove the steering column trim. There are two fasteners at the bottom of the trim that need to be removed. Once you do that, take both pieces off. There are two holes on the backside of the steering wheel to access the airbag release
Where does the wire go on a VW horn?
This wire goes to the horns on pin 2 of the horn connector. Pin 1 of the horn connector is spliced to a ground wire in the headlight harness.”
Where is the horn on the steering wheel?
In Cart! This unit installs at the bottom of the steering wheel. The ring contacts the horn tabs on the turn signal switch. The plastic tab works with the turn signal to turn off the signal. In Cart! In Cart!
What to do if your car horn does not work?
If your horn does not work with direct power to it them you will need to replace your horn. -If you have a multimeter, disconnect the plugs on the horns and have a friend push on the steering wheel as if they were trying to activate the horn (note: ignition switch must be on).