What do I need to replace my stereo in my Jeep?
In the case of 6-1/2″ or 5-1/4″ replacements, a speaker adapter bracket is required, and it’s available at a discount with your speaker purchase. Once the speaker and bracket are attached, you’ll shave the tabs off of the enclosure to make that combo fit flush.
How do you change the stereo in a Chevy?
Pry up the grille/defroster panel to release several retaining clips, then twist the sensor assembly to release it. Remove the panel and set it aside, then remove the two 7mm screws securing the speaker. Pull it out, disconnect it, and remove it.
How do you replace the stereo in a HHR?
Lift the panel, disconnect the wiring harnesses and the door release cable, then remove the door panel. If you have the standard system, you’ll remove one 7mm screw and unhook the speaker. If you have the Pioneer, you’ll remove four Phillips screws. The base speakers can be replaced with 5-1/4″ or 6-1/2″ speakers.
Where are the speakers on a Chevrolet HHR?
The HHR has speakers in the front doors, A-pillars, and rear doors. As with most vehicles these days, replacing the HHR’s factory speakers starts with removing the front door panels. What you find behind the panels depends on your truck’s factory stereo system. If your HHR is equipped with the base stereo, you’ll find a pair of 6-1/2″ speakers.
Is it possible to replace an old speaker?
If you are trying to improve your speaker or an exact replacement is not available, then you will have to do a little more work to find a suitable driver. For any replacement driver, you must ensure that it matches the speaker’s crossover specifications. Each driver can only handle certain frequencies and wattages.
How do you remove a speaker from a box?
Unplug any wires coming into or out of the speaker to ensure that it is not hooked up to any sort of power source. Unscrew the guide screws holding the driver to the box. Hold onto the driver while removing the final screw to ensure it doesn’t fall.
Where are the speakers on a Chevy Silverado?
You’ll find 4″x6″ speakers in the rear doors in this extended cab Silverado or Sierra, or if you have the Bose system, a round speaker in a 4″x6″ bracket. Once you’ve used a panel tool to remove the door panels to get these speakers, they’re extremely easy to take out, thanks to their clip-in plates.
Can a speaker be replaced at 100 watts?
For any replacement driver, you must ensure that it matches the speaker’s crossover specifications. Each driver can only handle certain frequencies and wattages. For example, if your stereo system is operating at 100 Watts but your driver can only handle 75 Watts then you are in danger of damaging it.