What causes the stem of a valve to wear out?
For the stem packing, the lack of elasticity that narrows the sealing gap causes the wear. This is especially true in the case of the combination of inelastic packing material and gland bolts. For the smaller valves, the only solution is to replace them after all, they are readily available.
Do you have a bad transmission valve body?
You may even hear them simply from changing gears. If the answer is yes to any or all of these scenarios, then chances are you may have a bad transmission valve body. If you try to change gears with the shifter and you notice it slips regularly, then you may have a problem with the transmission valve body.
Why is my TCC regulator valve not working?
The TCC regulator valve is supplied by line pressure, which is controlled by the EPC circuit. If line rise is poor because of a dirty EPC solenoid or leakage within that circuit, then feed to the TCC regulator valve will be poor (the solenoid can be replaced with [56842B-01]).
Can a wrong valve size calculation cause a bottleneck?
The wrong valve size calculation can lead to either undersized or oversized valves. This is important because the flow of media depends on the size of the valve. An oversized one can decrease the pressure whereas an undersized valve can cause bottlenecks. Find an online valve sizing calculator.
Is there a problem with the transmission valve body?
There are a few transmission valve body symptoms that keep you aware of failure activity of the engine. Most of them are quite noticeable. It is recommended that you should fix these problems as soon as possible. Then, your driving ability will be protected and gear changing will be smooth as usual.
For the stem packing, the lack of elasticity that narrows the sealing gap causes the wear. This is especially true in the case of the combination of inelastic packing material and gland bolts. For the smaller valves, the only solution is to replace them after all, they are readily available.
The TCC regulator valve is supplied by line pressure, which is controlled by the EPC circuit. If line rise is poor because of a dirty EPC solenoid or leakage within that circuit, then feed to the TCC regulator valve will be poor (the solenoid can be replaced with [56842B-01]).
The wrong valve size calculation can lead to either undersized or oversized valves. This is important because the flow of media depends on the size of the valve. An oversized one can decrease the pressure whereas an undersized valve can cause bottlenecks. Find an online valve sizing calculator.