What are the dimensions of a cassette tape insert?
The J-cards in total measure 104mm wide by 101.5mm high, with the front panel measuring 65mm wide by 101.5mm high, the spine measuring 12.5mm wide by 101.5mm high and the rear tab measuring 26.5mm wide by 101.5mm high. The J-cards are provided die creased with the spines ready to easily fold.
What is a cassette insert?
A J-card is the paper card inserted in the plastic storage case of most audio cassette releases, as well as being latterly wrapped around the outside of many Blu-ray and DVD steelbooks and similar special editions. Most J-cards contain the title of the content on the edge for quick reference while in storage.
What size is AJ card?
Both fold down to the standard 2 in. x 3.5 in. size.
What is jCard?
jCard is an interface between the ISO-8583 world and a double-entry accounting system. — or better yet – jCard is an interface between the ISO-8583 v2003 based jPOS-CMF world and a multi-layer, multi-currency general purpose double-entry accounting system (miniGL).
How big is a cassette cover?
These spools and their attendant parts are held inside a protective plastic shell which is 4 by 2.5 by 0.5 inches (10 cm × 6.3 cm × 1.3 cm) at its largest dimensions. The tape itself is commonly referred to as “eighth-inch” tape, supposedly 1⁄8 inch (3.17 mm) wide, but it is slightly larger: 0.15 inches (3.81 mm).
What is a tape J?
A J-card is the paper card inserted in the plastic storage case of most audio cassette releases, as well as being latterly wrapped around the outside of many Blu-ray and DVD steelbooks and similar special editions.
What are the specs for a cassette insert?
Cassette Insert Specifications For printing, always include a bleed and safety-margin of 1/8″. Bleed means that your art should extend 0.125″ beyond the edges of the card to avoid showing white space if the cut is off a bit.
How many stereo tracks are there on a cassette tape?
Two stereo pairs of tracks (four total) or two monaural audio tracks are available on the tape; one stereo pair or one monophonic track is played or recorded when the tape is moving in one direction and the second (pair) when moving in the other direction.
How are cassette singles supposed to be made?
Originally, most cassette singles were released in a thick paper sleeve that slipped over the outside of the cassette. This was then usually shrink wrapped in cellophane plastic. Some singles contained one song on each side, much as 7-inch 45-rpm records had done, but others repeated the songs on both sides.
How to make your own cassette cover template?
If using PDF templates, send two files: one with template lines showing, and one without. Available by special request. To make your own simply double the height of the template. A U-card is shaped like a U. The back panel covers the entire back of the cassette case.