Is it OK to remove the main tensioner cover?
However, you can leave the black water pump and main tensioner covers attached, no reason to remove them since you are removing the entire timing cover.
Do you have to install new tensioner when replacing timing chain?
If you’re replacing it, the new tensioner should come with a pin already installed in the hole. Leave it in place until you’re completely done with the chain installation.
What causes the slack guide to drop off on a Nissan?
Here’s the main problem, the ‘slack guide’ as Nissan calls it. This part seems to have been engineered with plastic that is too brittle, and too thin near the top, causing it to break off and drop down after some time in the oil.
How many miles does a 2005 maxima have?
Quick overview of where we’re at here: Front of a 2005 Maxima VQ with 55k miles, this was an AT but that doesn’t matter since the oil pan is already removed. I’m doing this while I’ve got it out of the car so I don’t have to do it again for a long while.
How much does a belt tensioner for a Nissan Maxima cost?
The best part is, our Nissan Maxima Belt Tensioner Assembly products start from as little as $43.29. When it comes to your Nissan Maxima, you want parts and products from only trusted brands.
What kind of pulley does a Nissan Maxima use?
Use the fitment form at the top of the page to select your exact year and engine type for your Nissan Maxima. Manufactured by one of the world’s largest Original Equipment supplier of accessory drive tensioners and pulleys. Heavy Duty Steel Pulley with close tolerance ball bearing pocket. 6203 bearing. I highly recommend this part.
What kind of belt tensioner does an Infiniti QX60 use?
This accessory drive tensioner is designed and engineered by Litens – the worlds largest supplier of original equipment (O.E.) belt tensioners in the world. This part was designed for the 2013-2018 Nissan Altima,Pathfinder,Murano, Quest / 2013 Infiniti JX35 / 2014-2015 Infiniti QX60 with 3.5L.
When to change the tensioner on a belt?
Due to the fact that belts and tensioners have similar Original Equipment “design life targets”, it is often a best practice to replace the belt tensioner when replacing a worn or broken belt. Belt removal is required to change the tensioner.